Overview
The Rugged Ridge A-Pillar Switch Pod (part number 17235.58) mounts on the driver’s side A-pillar and has premolded cutouts for up to four aftermarket switches. The cutouts place the switches in easy reach and out of the way of the shifter handle.
The pod has a textured molded finish like the factory plastic pillar cover it replaces, and it snaps into place like the original part. It fits 2 and 4-door models, and it will not work with front cage supports installed.
Key features
- Premolded cutouts for four aftermarket switches
- Driver’s side A-pillar placement
- Textured molded finish matching the factory pillar cover
- Snaps into place like the original cover
- Fits 2 and 4-door models
Cage supports and pillar pods
Roll cages change how a pillar mount sits, so look at the bars before choosing a location for an A-pillar pod. Some builds add front supports that run close to the dash, and those can block a pod from seating or put switch cables in the way. Measure the clearance from the cutouts to any bars and padding before deciding which switches go where.
Seat belt anchors and cage padding also matter. Keep switch cables clear of belts and moving parts, and secure them with clips so they do not rub. If the cage changes later, recheck the pod position, since a new bar can change the fit.
- Measure clearance from the cutouts to nearby bars
- Keep cables clear of seat belts and moving parts
- Recheck the pod after any cage change
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 17235.58 |
| UPC | 804314237509 |
| Switch capacity | 4 switches |
| Mounting location | Pillar, driver’s side A-pillar |
| Body styles | 2 and 4-door models |
| Finish | Textured molded |
Vehicle fitment
It is a pillar mount for 2 and 4-door models.
The pod will not work if front cage supports are installed, so do not fit it to a vehicle with those supports. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Do not fit the pod to a vehicle with front cage supports. Check your roll cage setup first, then set the pod in place and plan each switch’s wiring before final assembly.
What’s included
Check the package contents against your installation before starting.









