Overview
The Rubicon Express RE1935 is a standard leaf spring perch for 2.5 inch wide springs, part number RE1935, sold as a pair. It is a universal builder part, not a vehicle-specific bracket, and welding is required to mount it.
The perch is made from 1/4 inch steel with a 6 inch contact area for the spring. It has offset pads for welding against the front differential, and its taller profile provides clearance for steering under the spring. It is intended for spring-over applications only.
Key features
- 1/4 inch steel construction
- 6 inch contact area with the spring
- Multiple center pin holes for wheelbase adjustment
- Offset pads for welding against the front differential
- Taller profile for steering clearance under the spring
Setting up the spring layout
A perch is only one part of the spring mount, so decide on wheelbase and axle position before cutting or welding anything. The center pin holes allow small wheelbase changes, and the pin should sit where the spring can flex without pulling against the body. Mark the spring center on the axle and confirm that the perch sits square to the spring and the axle tube before tacking it in place.
Because the offset pads are set up for welding against the front differential, a clean, bare surface improves the weld and reduces porosity. Use a welding process suited to steel and avoid welding over paint or rust. After welding, check the spring seat and its clearance to steering components and the driveline.
- Confirm the spring-over layout before welding
- Check steering and driveline clearance once the spring is seated
- Re-check wheelbase measurements before final welds
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1935 |
| UPC | 614901439915 |
| Sold as | Pair |
| Spring width | 2.5 inch |
| Material | 1/4 inch steel |
| Spring contact area | 6 inch |
| Installation | Welding required |
| Application | Spring-over; not suitable for spring-under |
Vehicle fitment
This is a universal builder part rather than a vehicle-specific bracket. The 2.5 inch spring width is the sizing point to check against your spring before welding.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required. The offset pads are designed for welding against the front differential, and the perch is not suitable for spring-under applications, so confirm the spring-over layout before welding. Have an experienced welder do the work if you are not confident in welding steel suspension parts.
What’s included
A pair of perches.







