Select your vehicle

Trail Gear Leaf Spring Perch Kit – 110028-1-KIT

Trail Gear

Shop Trail Gear Leaf Spring Perch on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Trail Gear leaf spring perch kit, part number 110028-1-KIT
  • Unpainted perches made from 1/4 plate steel
  • Optional holes allow the rear axle to move forward or back 1 inch
  • No vehicle fitment listed

Description

Overview

The Trail Gear leaf spring perch kit, part number 110028-1-KIT, supplies unpainted perches made from 1/4 plate steel for rear leaf springs. Its main use is lifted rear springs, where the pinion has to be rotated so it points at the rear transfer case output flange, which usually calls for a CV style drive shaft.

Key features

  • Made from 1/4 plate steel
  • Unpainted finish
  • Center spring pin hole for standard placement
  • Optional holes let the rear axle move forward or back 1 inch

Driveline angles after a lift

Lifting a vehicle changes the angle between the transfer case output and the pinion, and that angle is where most driveline trouble starts. Rotating the pinion with new perches can bring the angle back toward the transfer case flange, but the change should be measured rather than guessed. A CV style driveshaft often comes into play because the angle change can exceed what a standard shaft tolerates.

Before welding new perches, measure the pinion angle with the vehicle at its normal ride height and set the axle at the intended position. Use the adjustment holes to fine tune axle placement only after the angle is confirmed. After installation, check the driveline under load and listen for vibration at speed. Recheck the bolts after the first drives because the new welds and spring seats can settle.

Specifications

Brand Trail Gear
Part number 110028-1-KIT
UPC 70000621553
Type Kit
Material 1/4 plate steel
Finish Unpainted
Axle adjustment 1 inch forward or backward using optional holes

Vehicle fitment

The kit is aimed at lifted rear leaf spring setups. Confirm your spring and axle arrangement before ordering.

No specific vehicle is named for this kit. Confirm your vehicle’s year, model and trim before ordering.

Installation notes

The old perches are cut off and a new set is welded in at the proper angle, so this is a fabrication job. Rotating the pinion for lifted springs typically requires a CV style drive shaft, and welding should be done by someone experienced with driveline angles.

What’s included

No specific vehicle is named for this kit. Confirm your vehicle’s year, model and trim before ordering.

SKU: TGI110028-1-KIT Category:

Specification

Shipping weight 4.00 lbs
Package dimensions 7.50 × 7.50 × 3.50 in
brands

Questions & Answers

Does the Trail Gear 110028-1-KIT fit a specific vehicle?

No vehicle is named for this kit. Check your lifted rear leaf spring setup and confirm fit for your vehicle's year, model and trim before ordering.

Why does the pinion need rotating with lifted springs?

With lifted rear springs, the pinion should point at the rear transfer case output flange, which typically calls for a CV style drive shaft. The kit is used to cut off the old perches and weld a new set at that angle.

Can the rear axle position be adjusted with this kit?

Yes. The spring pin normally goes in the center hole, and optional holes allow the rear axle to be moved forward or backward 1 inch.

How do I tell if the pinion angle is off?

Vibration under acceleration, or a driveshaft that shudders at highway speed, can point to pinion angle trouble. Measure the angle at the pinion and transfer case with a level or angle gauge before making any changes.

Find it on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Shop Trail Gear Leaf Spring Perch on Amazon