Overview
The Rubicon Express RE1900 is a weld-on spring pad for springs 2 inches wide. It is a universal builder part in bare steel, and the package includes one individual spring perch.
The pad is made from 1/4-inch steel with a 6-inch contact area for the spring. Its offset makes welding against the front differential more straightforward, and the taller profile creates clearance for steering under the spring. It is not suitable for spring-under applications.
Key features
- Weld-on spring pad for 2-inch wide springs
- Offset pad design
- 1/4-inch steel construction
- 6-inch contact area
- Multiple center pin holes for wheelbase adjustments
- Taller profile for steering clearance
Pairing pads with spring width
A weld-on spring pad sets the point where the spring meets the axle, so its size and placement shape how the spring loads and how the axle moves. A pad built for 2-inch wide springs only works if the spring you have is that width, so measure before ordering and keep notes on the spring pack you plan to use.
Because the RE1900 is a single perch, plan for two when building a pair. Check that both pads sit at matching heights and angles on the axle, since uneven placement can cause the spring to load one side harder than the other. Fabricators often tack both pads, then check them against each other before finishing the welds.
- Confirm spring width on both sides
- Keep the offset facing the same direction on each pad
- Recheck pad welds after the first few trail runs
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1900 |
| UPC | 614901439861 |
| Type | Weld-on spring pad |
| Spring width | 2 inches |
| Offset | Yes |
| Steel thickness | 1/4 inch |
| Contact area | 6 inches |
| Quantity | One individual perch |
| Fitment | Universal fit |
Vehicle fitment
This is a universal builder part and no vehicle is named. Match the 2-inch spring width to your spring before welding the pad in place.
Confirm the spring width and mounting position on your axle before ordering, since this pad is not suitable for spring-under applications.
Installation notes
Welding is required. Set the pad in position on the front differential side with the offset facing that way before the weld is made.




