Overview
The Rubicon Express RE7531 is an Extreme-Duty Long Arm Rear Tri-Link upgrade for Jeep Wrangler TJ owners who already run a Super-Flex short arm suspension. It is designed to improve on-road handling with a close-to-stock ride and to perform on demanding trails.
The tri-link layout removes the rear track bar, which allows true up and down wheel travel and adds anti-squat for steep climbs. The kit is bolt-on for factory Dana 35 and Dana 44 rear ends and includes front and rear control arms made from 4130 chromoly with a .250 wall.
Key features
- Chromoly Extreme-Duty long arms
- PT-Meg Super-Ride bushings
- Three-piece belly pan
- Rear stainless steel brake lines
- Builder Ball misalignment joint with up to 32 degrees of misalignment
- Eliminates the rear track bar
Tri-link maintenance and setup
A tri-link layout controls the axle with arms rather than a track bar, so the axle position and steering stability depend on the arms and their joints. Keeping the bushings, joints and brake lines in good shape helps the axle stay where it belongs under load. Because the geometry changes with travel, the setup is best checked after any change to lift or tires.
Stainless steel brake lines should be routed clear of moving parts and the axle through full travel. Check for kinks, rub points and fitting leaks after the install and again after a few trail sessions. Keep the belly pan secured, since it protects the transfer case and transmission from debris.
- Check brake lines for rub points after install
- Inspect the belly pan fasteners on a regular basis
- Confirm axle alignment after lift or tire changes
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7531 |
| UPC | 614901442106 |
| Suspension type | Long arm tri-link |
| Rear axle | Dana 35 or Dana 44 |
| Control arm tubing | 4130 chromoly, .250 wall |
| Misalignment joint | Builder Ball, up to 32 degrees |
Vehicle fitment
It fits the Jeep Wrangler TJ in the 1997 to 2006 range, for owners who already run a Super-Flex short arm system.
It is for the TJ only, so later Wranglers and the LJ are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The three-piece belly pan is part of the kit and must be fitted for transfer case and transmission access. Lift height depends on the system being upgraded, so confirm the current setup first, then check alignment and driveline angles after the work is finished.
The kit includes rear stainless steel brake lines. The Builder Ball allows up to 32 degrees of misalignment and sits in a 3-inch OD housing. Lift is set by the existing short arm system being upgraded.
Fitment to the rear is for factory Dana 35 and Dana 44 axles. Lift height depends on the system being upgraded, so check the package contents against the parts you need before the install.
What’s included
Front and rear chromoly control arms, PT-Meg Super-Ride bushings, the three-piece belly pan, rear stainless steel brake lines and the Builder Ball misalignment joint.


