Overview
The Rubicon Express RE1930 is an anti-wrap spring perch for springs 2.5 inches wide. It is a universal builder part in bare steel, and it is sold as a pair that has to be welded into place.
The perch is made from 1/4-inch steel with a 6-inch contact area for the spring. Its offset pads make welding against the front differential easier, and its taller profile gives steering clearance under the spring. It is not suitable for spring-under applications.
Key features
- 1/4-inch steel construction
- 6-inch contact area with the spring
- Multiple center pin holes for wheelbase adjustment
- Offset pads for welding against the front differential
- Taller profile for steering clearance under the spring
- Sold as a pair
Setting up a spring perch
A spring perch gives the spring a seat on the axle, and the spring’s position determines how the axle sits under load and how much the axle can rotate. Setting the perch square to the axle and level from side to side keeps the spring working evenly. Mark the position with the spring installed and the vehicle at ride height before tacking anything in place.
Before welding, check that the spring, shock and brake lines clear the perch through full travel. Preheat if the steel is thick, and weld in short passes to limit distortion. After the first few drives, look over the welds and the spring seat for cracks, since spring loads concentrate at the joint.
- Mark perch position at ride height
- Check clearance for brake lines and shocks
- Weld in short passes to limit distortion
- Inspect welds after the first trail runs
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1930 |
| UPC | 614901439908 |
| Type | Anti-wrap spring perch |
| Spring width | 2.5 inches |
| Steel thickness | 1/4 inch |
| Contact area | 6 inches |
| Finish | Bare steel |
| Sold as | Pair |
| Fitment | Universal fit |
Vehicle fitment
The perch is a universal builder part, so no vehicle is named. Its suitability depends on the spring width and the axle you weld it to.
Confirm the spring width and that a conventional mount suits your build before ordering, because this perch is not suitable for spring-under applications.
Installation notes
Welding is required, and the offset pads are designed for welding against the front differential. Choose the center pin hole that gives the wheelbase you need before welding.





