Overview
The Rubicon Express RE1920 is an anti-wrap spring perch for 2.5-inch wide springs. It is a universal builder part supplied as bare steel, sold as a pair, and it has to be welded to the axle.
The perch is made from 1/4-inch steel and provides a 6-inch contact area for the spring. Its offset pads are meant for welding against the front differential, and the taller profile creates clearance for steering under the spring. It is not suitable for spring-under applications.
Key features
- 1/4-inch steel construction
- 6-inch contact area with the spring
- Multiple center pin holes for wheelbase adjustments
- Offset pads for front differential welding
- Taller profile for steering clearance
Setting the perch position
An anti-wrap perch holds the spring seat at a fixed point on the axle, which helps keep the spring from twisting the axle under hard acceleration and braking. Because the spring load passes through that seat, its location affects how the spring arcs and how the axle rotates. Small changes in placement can shift pinion angle, so mark the layout on the axle before any metal is cut or welded.
Welding is the main job. A qualified fabricator should square the perch to the axle, clean the mating surfaces to bare metal, tack it in place, and check alignment with the spring pack before the final weld. Once the vehicle is on the ground, recheck spring center and shackle travel to confirm the new position works.
- Measure the spring width before cutting any steel
- Mark pinion angle and spring arc on the axle first
- Inspect welds and spring seats after the first trail runs
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1920 |
| UPC | 614901439885 |
| Type | Anti-wrap spring perch |
| Spring width | 2.5 inches |
| Offset | Yes |
| Finish | Bare steel |
| Sold as | Pair |
| Fitment | Universal fit |
Vehicle fitment
No vehicle is named for this universal fit spring perch. Check the spring width and the axle mounting point before welding it in.
Confirm the spring width and that the perch is a conventional under-axle mount for your build before ordering.
Installation notes
Because the perch is bare steel and requires welding, it should be welded by a qualified fabricator who can set its position on the axle.






