Overview
The Rubicon Express RE7504M is a 4.5-inch Extreme-Duty long arm lift kit with a rear Tri-Link and mono tube shocks, made for the 1997–2002 Jeep Wrangler TJ. It sits in the 3 to 4.99-inch lift range.
The long arm design replaces the stock suspension arms with longer control arms, which improves the geometry of a lifted vehicle. The longer arms give more stability on and off road than standard short arm lifts, with less torque roll and better trail traction.
The rear Tri-Link replaces the rear track bar, so the axle moves up and down without the side constraint of a bar. The link adds anti-squat for steep climbs and improves tracking on the road. Mono tube shocks are included with this version of the kit.
Key features
- Chromoly long arms made from 4130 chromoly tubing
- Rear Tri-Link in place of the rear track bar
- Builder Ball misalignment joint, rated by Rubicon Express for up to 32 degrees of misalignment
- Adjustable control arms with serviceable Super-Flex spherical ball joints
- PT-Meg Super-Ride bushings
- Mono tube shocks included
- Tuned lift springs and stainless steel brake lines
Long arm alignment basics
Long arm kits move the axle mounting points, so the pinion angle and steering geometry change. Driveline vibration at highway speed is often the first sign of an angle that needs work. A tire rotation and a driveshaft inspection are simple places to start, and a shop with lift experience can measure the angles precisely.
Once a Tri-Link is in place, the bushings and joints carry more load at the rear end. Look for torn boots on the Builder Ball and heat or noise from the bushings during routine service. Greasing the joints and inspecting the mounting bolts after the first few trail runs helps the system stay tight.
- Inspect the Builder Ball boot and housing
- Recheck Tri-Link bolts after the first trail runs
- Measure pinion angle after the long arms go in
- Check brake hose length at full droop
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7504M |
| UPC | 614901452938 |
| Lift height range | 3 to 4.99 inches |
| Suspension type | Long arm |
| Kit type | Extreme-Duty long arm |
| Rear lift method | 3-link (Tri-Link) |
| Control arm material | 4130 chromoly, .250 wall |
| Misalignment joint | Builder Ball, up to 32 degrees, 3 inch OD housing |
| Belly pan | Three-piece, for transfer case and transmission access |
| Shocks included | Yes, mono tube |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1997–2002 Jeep Wrangler (TJ), including the SE, Sahara and Sport models.
Confirm your vehicle’s year, model and trim before ordering, including whether it is a 2003–2006 TJ, JK or YJ.
Installation notes
The kit is a full long arm replacement, so alignment and driveline angles need checking after installation. It is bolt-on for factory Dana 35 and Dana 44 rear axles.
What’s included
The kit includes front and rear control arms, the rear Tri-Link, the Builder Ball, PT-Meg Super-Ride bushings, tuned lift springs, stainless steel brake lines, mono tube shocks and a three-piece belly pan.











