Overview
The Rough Country Ford dual steering stabilizer (part number R/C8733630) is a stacked-mount kit with one stabilizer on top of the other. It fits the 1977–1979 Ford F-100 and F-150, the 1977–1979 Ford Bronco and the 1977 Ford Bronco Sport.
The stabilizers restrain bump steer and front-end vibration, which helps when running aftermarket tires. The 18mm chrome hardened piston rod and large cylinder damp vibration on the trail, and the kit can be installed at home with common tools.
Key features
- Stacked-mount design with one stabilizer on top of the other
- Dual stabilizer configuration
- Chrome hardened 18mm piston rod
- Large-bodied cylinder for vibration damping
- Brackets included
- Bolt-on installation
Stacked mounts on older trucks
Stacked dual stabilizers put two damping units in line at the same mount point, which can add control on older trucks with worn steering. The added damping is useful when tires get larger or the steering box and linkage have some play. Because the stack sits close to the tie rods, clearance matters at full steering lock.
Older frames and brackets tend to rust, so the mount points deserve a look before and after installation. Check the rods for oily residue, and confirm the stabilizers do not contact the tire, the track bar or the linkage through full travel. Fasteners should be checked after the first drives, since older hardware can loosen under vibration.
- Check frame mount points for rust
- Inspect rod seals for oily residue
- Confirm clearance around the tire at full steering lock
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C8733630 |
| Single or dual | Dual |
| Position | Front |
| Mount design | Stacked |
| Piston rod | 18mm chrome hardened |
| Brackets | Included |
| Shock boot | Not included |
| Fitment | Direct fit |
Vehicle fitment
It fits 1977–1979 Ford Bronco (Custom, Northland and Ranger XLT trims), the 1977 Ford Bronco Sport, and 1977–1979 Ford F-100 and F-150 in Ranger, XLT and Custom trims. Make sure the year, model and trim match your truck before ordering.
The list covers only the 1977–1979 trucks named above. Other Ford models and years are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit includes brackets for a complete bolt-on set. Shock boots are not included, so plan to source one separately if your setup uses them.
What’s included
Brackets are included with the dual stabilizer kit. The shock boot is not included.









