Overview
The Rock Krawler Rear Coil Springs (3″ Lift), part number RKSRK07328, are rear coil springs for the 2020–2026 Jeep Gladiator (JT) and provide a 3-inch rear lift.
This is the JT rear coil spring, a single spring for the rear position. It fits the 2020–2026 Jeep Gladiator JT models.
Key features
- 3-inch rear lift
- Rear position, JT Gladiator
- Direct fit listed
Rear height and driveline
A rear spring change lifts the back of the Gladiator relative to the front. This shifts the pinion angle and can increase vibration at highway speed if the angle becomes too steep. Once the new spring is in, inspect the driveline for binding and check the U-joints for wear, since a changed angle loads them differently than the factory setup did.
The brake lines and the rear shock mounts also move with the new height. Look for stretched brake hoses, check that the shocks can reach full extension without strain, and make sure the rear sway bar links are still seated. Because the rear and front heights now differ, a front spring change or a new front shock may be considered later to even the stance. Recheck the fasteners after the first few drives.
Specifications
| Brand | Rock Krawler |
|---|---|
| Part number | RKSRK07328 |
| Position | Rear |
| Lift | 3 inches |
| Fitment type | Direct fit |
Vehicle fitment
This rear spring fits the 2020–2026 Jeep Gladiator (JT) 80th Anniversary, Altitude, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport models.
The front springs and the Wrangler JL are not covered by this part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Changing only the rear spring raises the rear of the Gladiator relative to the front. Check the rear driveline angle and the brake lines after installation.
What’s included
One rear coil spring. Verify the contents against the installation steps before starting.









