Overview
The Rock Krawler High Steer Front Track Bar Bracket, part number RKSRK04481K, is an axle-side track bar relocation bracket for the Jeep Wrangler JK. It is made from plate steel with a black powder coat finish and fits 3.5 to 6 inch lifts. It is made in the U.S.A. and fits 2 and 4 door JK models.
The bracket moves the front track bar’s mounting point at the axle, which changes the bar’s height and angle and affects the roll center. It is matched to the geometry of the drag link flip kit, a pairing used to limit bump steer.
Bump steer is the change in steering direction that can happen as the suspension moves up and down. A track bar and drag link set to matching geometry is the usual way to limit it, so the matched geometry is the main reason to pair this bracket with the company’s drag link flip kit.
Key features
- Axle-side track bar relocation bracket
- Plate steel construction
- Black powder coat finish
- Fits 3.5 to 6 inch lifts
- Geometry matched to the drag link flip kit
- Made in the U.S.A.
Choosing a high steer setup
A track bar keeps the front axle centered side to side, and a drag link keeps the steering linkage moving in step with it. When the suspension travels up and down, the two parts can move along different arcs, and that mismatch is what causes bump steer. Relocating the track bar to the axle changes its arc so it can line up better with the drag link.
Because the bracket changes the bar’s angle, the drag link and track bar are best chosen as a pair. Mixing a relocation bracket with an unmatched drag link can bring back the steering wander the setup was meant to remove. Pick the bracket and drag link together so the geometry stays consistent across the lift range you run.
Worn track bar ends and bushings add play that makes any geometry change harder to set correctly. Inspect them before installing the bracket, and replace anything loose so the new angle is accurate. After the install, drive slowly on a flat road and check for wander or steering that feels off center.
- Check the track bar ends and bushings for play
- Match the drag link to the bracket geometry
- Plan welding time or a shop installer ahead of the install
Specifications
| Brand | Rock Krawler |
|---|---|
| Part number | RKSRK04481K |
| Position | Front |
| Type | Axle-side track bar relocation bracket |
| Material | Plate steel |
| Finish | Black powder coat |
| Lift range | 3.5 to 6 in. |
| Installation | Welding required |
| Origin | Made in the U.S.A. |
Vehicle fitment
The bracket fits 2007 to 2018 Jeep Wrangler (JK) models, including two-door and four-door bodies. Trims include 70th and 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X.
Wrangler TJ, JL and LJ models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, so this bracket is not a bolt-on part. Have it installed by a shop or installer equipped to weld, and have the track bar angle and alignment checked afterward.
What’s included
The axle-side track bar relocation bracket. Compare the parts you have against your installation plan before you start.








