Overview
The Rancho RS711 is a U-bolt kit, part number RS711, from the suspension block and U-bolt category. It is a U-bolt kit for suspension mounting, and the included hardware is listed below.
Torque checks for U-bolts
U-bolts clamp an axle or spring pack to the mounting plate, so their grip depends on even tightening and clean threads. Clean the threads and the plate surface before assembly so the clamp load is consistent. Thread the nuts by hand first, then tighten them in a cross pattern so the plate seats evenly. Use a torque wrench set to the value in your service manual rather than tightening by feel.
Bolts can stretch or loosen after the first few miles on rough terrain, so retighten them after initial use and again at routine service intervals. Check for rust or thread damage, and replace any U-bolt that shows a bend, stretch or missing threads. Keep spare nuts on hand, since a loose nut can quickly lead to a shifted axle.
- Hand-start every nut before tightening
- Re-torque after the first trail run
- Inspect threads for rust at each oil change
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS711 |
| UPC | 39703711005 |
| Included hardware | 4 U-bolts, 8 washers, 8 nuts |
| Category | Suspension block and U-bolt kit |
Vehicle fitment
Rancho marks this kit direct fit but names no year, make or model. Match the U-bolts to your axle and spring setup before using them.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Four U-bolts, eight washers and eight nuts.








