Overview
The Rigid Industries Radiance Backlight, part number 250023, is a 50-inch LED light bar with a red lens, sold in Rigid’s Radiance Plus line. Fit is universal: Rigid does not tie this bar to a particular truck, SUV or off-roader, so suitability depends on whether your vehicle has a mounting spot for a 50-inch bracket bar.
The Radiance Plus uses improved LED technology that puts up to 35% more raw lumens out than earlier bars. The housing is high-grade aluminum alloy, the same used on the E-Series, and the interior has a black exposed circuit board. Broad spot optics blend spot and flood patterns, and the back-lighting can be set to white, amber, red, blue or green. Large back-lit branding plates sit on the bar face, and a wiring harness and multi-trigger switch come with the bar.
Key features
- Improved LED technology with up to 35% more raw lumens than earlier bars.
- High-grade aluminum alloy housing shared with the E-Series bars.
- Broad Spot optics that combine a spot and a flood beam pattern.
- Black exposed circuit board behind the lens.
- Large back-lit, recently updated Rigid branding plates.
- Wiring harness and multi-trigger switch included.
Wiring and fuse planning
Wiring a light bar takes more planning than the bar itself. Run the positive feed through a fuse close to the battery and, where practical, through a relay so the bar draws current directly from the battery rather than through dash wiring. Choose a ground point on bare metal and clean any paint away first, since a weak ground causes flicker and heat. Route the harness so it stays clear of exhaust heat, sharp edges, moving suspension parts and the engine bay.
A multi-trigger switch is convenient when the bar is controlled from the cab. Mount the switch where you can reach it without looking, and secure the cable so it does not dangle. Seal every connector with dielectric grease or heat-shrink, and use drip loops where the wire enters the body. Check the wiring after the first few drives and whenever you clean the bar, since loose terminals show up as dimming or buzzing.
- Fuse the feed close to the battery
- Use a relay for higher current
- Make the ground connection on bare metal
- Seal connectors against moisture
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 250023 |
| UPC | 849774028823 |
| Size | 50 inch |
| Lens color | Red |
| Bulb type | LED |
| Type | Light bar |
| Mounting type | Bracket |
| Optics | Broad Spot |
| Housing | High-grade aluminum alloy |
| Back-lighting | White, amber, red, blue, green |
| Fitment | Universal Fit |
Vehicle fitment
This light bar is not vehicle-specific. Universal Fit means Rigid does not match it to a particular make or model, and the 50-inch length and your mounting location decide whether it works.
Measure the planned mounting position for a 50-inch bar and its bracket before you finalize the spot.
Installation notes
The wiring harness and multi-trigger switch are the only wiring this bar needs. Fuse the feed at the battery, route cable away from heat and moving parts, and check local rules on auxiliary driving lights before using the bar on public roads.
What’s included
Wiring harness and multi-trigger switch.









