Overview
The Rigid Industries RDS-Series PRO 50-inch LED light bar, part number 885213, is an offroad light built from the E-Series design with a gentle arc. The curve lets it sit against the curved windshields and bumpers on today’s trucks and SUVs, and Rigid marks it Universal Fit, so it is not built around one vehicle model.
The PRO version reaches up to 70% more raw lumens than earlier RDS-Series bars, thanks to improved LED technology. The arc also widens the LED spread, so one 50-inch bar covers ground that would otherwise need several smaller lights.
The Midnight Edition adds an exclusive spot optic with a transparent black enamel coating and black oxide hardware, so the bar looks subdued in daylight and still lights the night. Its light output is higher than before. Midnight Optics are available in E-Series, RDS-Series and D-Series product lines.
Key features
- Curved RDS-Series PRO housing that follows the lines of modern windshields and bumpers
- Up to 70% more raw lumens than earlier RDS-Series bars
- Wider light spread from the arc, giving broad coverage from a single bar
- Midnight Optics option with a transparent black enamel coating on the spot optic
- Black oxide hardware on the Midnight Edition for a stealth look
- Blacked-out circuit boards and updated Rigid branding on the PRO line
Setting up a 50-inch bar
A bar this long needs a mount that spreads the load along its full length. Use the mounting points that give the most support, and avoid bracketing only at the ends, which lets the housing flex on rough trails. Mark the position with the bar held in place so the arch sits cleanly against the surface before fastening.
Power draw matters with a wide LED array. Run the wiring through a relay with a properly rated fuse, and route the harness away from exhaust and moving suspension parts. Switch the bar from the cab so you can turn it off quickly when driving on paved roads near other traffic.
Midnight-style finishes look best when the bar stays clean. Wipe the optic regularly, and check the black oxide hardware for corrosion after wet or salty trips so the stealth look holds.
- Support the bar at multiple points
- Use a relay and a fuse
- Clean the optic regularly
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 885213 |
| UPC | 849774030093 |
| Series | RDS-Series PRO |
| Length | 50 inches |
| Light source | LED |
| Optic | Spot optic, with Midnight Optics option |
| Hardware | Black oxide on Midnight Edition |
| Circuit boards | Blacked-out |
Vehicle fitment
Rigid marks this light bar as Universal Fit, so it is not vehicle-specific. Check the 50-inch length and the arc against your intended mounting spot on the vehicle before choosing a location.
Installation notes
Measure the mounting surface before choosing a position, because the arched 50-inch housing needs clear room along its full length. Wire the bar through a properly rated fuse. Driving with auxiliary lights on public roads is governed by local law, so confirm what is allowed where you drive.
What’s included
Rigid does not spell out the included hardware or wiring harness for this part, so review the package contents before starting the install.









