Overview
The Pro Comp 51035B is a front upper control arm with stainless steel Uniball joints and a billet dust cap, sold as a pair for 2007–2014 GM 1500 2WD and 4WD trucks. Pro Comp built the Pro Runner arm to replace factory upper control arms, which the company says have weak ball joints and stamped steel construction that is not designed for off-road use.
The arm is made from 1.25-inch chromoly tubing with reinforced pivot bushing mounts. Pro Comp says those mounts eliminate flex and handle the added load from extreme suspension cycling. The arm is intended for lifted, leveled or stock trucks, and it is finished in black powder coat.
Key features
- Stainless steel FK Uniball joints in place of factory ball joints
- 1.25-inch chromoly tubular construction
- Large PTMEG pivot bushings for quiet operation
- Reinforced pivot bushing mount to resist flex
- Zerk grease fitting on the pivot bushings for easy service
- Billet machined dust cap keeps dirt and debris out of the Uniball
- Black powder coat finish
Choosing the right upper arm
Upper control arms are the top link of the front suspension, and their ball joints take the steering and suspension loads as the wheel moves. On a lifted or off-road truck, the joints and pivot bushings see more angle and more load than factory parts were designed for, which is why many owners replace the arms as a set.
When choosing arms, match the model years first, then compare the joint size, tubing and pivot design with the factory parts. Arms sold as a pair keep both sides consistent, which helps the truck track straight after the alignment.
Upper arm replacement often calls for new bushings, a lower ball joint check and a full alignment. Grease the zerk fittings at the recommended interval and inspect the dust caps for tears, since a damaged cap lets grit wear the joint.
- Match the model years before buying
- Replace bushings and inspect the lower joint together
- Align the front end after installation
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 51035B |
| UPC | 614901273601 |
| Position | Front upper |
| Tubing | 1.25-inch chromoly, tubular |
| Ball joints | Stainless steel FK Uniball |
| Bushings | PTMEG pivot bushings with zerk fittings |
| Dust cap | Billet machined |
| Finish | Black powder coat |
| Sold as | Pair |
Vehicle fitment
The arms are made for 2007 to 2014 GM 1500 2WD and 4WD trucks. Confirm that your truck is a GM 1500 from those years before ordering.
Model years 2014 and newer are not covered by this part. Pro Comp lists its 51036B arm for 2014 and newer GM 1500 trucks, which use a different upper arm. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Upper control arms set caster, camber and steering geometry, so have the front end aligned after the arms are installed. The pivot bushings have zerk fittings, so grease them once the arms are in place.
What’s included
Two upper control arms, sold as a pair. Each arm comes with a billet machined dust cap that keeps dirt and debris out of the Uniball joint.






























