Overview
The Pro Comp Suspension ES3000 324506 is a rear hydraulic shock for the 1981–1985 Toyota Pickup, covering the Base, DLX and SR5 versions. It uses factory upper and lower mounts, and its extended, collapsed and travel lengths are vehicle specific.
Pro Comp rates the shock for a 2.5 to 3 in. lift. Inside, the shock pairs 10-stage velocity-sensitive valving with a 5/8 inch chrome-hardened piston rod and a Teflon rebound stop in a twin tube cellular gas body. The double welded mounts add strength, and the shock carries the Pro Comp Suspension limited lifetime warranty.
Key features
- Twin tube cellular gas design
- 10-stage velocity-sensitive valving
- 5/8 inch chrome-hardened piston rod
- Teflon rebound stop
- Double welded shock mounts
- Factory upper and lower mounts
- Rear position, rated for a 2.5 to 3 in. lift
- Pro Comp Suspension limited lifetime warranty
Rear shock setup for Toyota Pickups
Rear shocks on older compact pickups work with the leaf springs or coil springs to keep the bed from bouncing when loaded. A worn shock lets the rear axle hop under acceleration and can make the tail feel loose on rough roads. Replacing the shock restores control, especially when the truck carries loads in the bed.
Because the lengths are vehicle specific, measure the old shock before ordering and compare the mount type. Inspect the bushings and spring perches, and replace any worn parts at the same time. Keep the mounting bolts snug and recheck them after the first drive on rough roads. Keep the shock clear of the exhaust and fuel lines during installation.
- Check bump stops and spring seats
- Inspect the rear axle for leaks
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 324506 |
| UPC | 614901041958 |
| Shock series | ES3000 |
| Position | Rear |
| Type | Hydraulic, twin tube cellular gas design |
| Extended, collapsed and travel lengths | Vehicle specific |
| Upper mount | Factory |
| Lower mount | Factory |
| Lift height rating | 2.5 to 3 in. lift |
| Adjustable | No |
| Remote reservoir | No |
| Finish | White |
| Boot included | No |
| Sold as | Each |
Vehicle fitment
It fits the 1981–1985 Toyota Pickup (Base, DLX and SR5).
Toyota Pickups from 1980 and earlier and from 1986 and later are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This rear shock is rated for a 2.5 to 3 in. lift, so check your Pickup’s suspension height before fitting. Measure the rear shock being replaced, because the lengths are vehicle specific.
What’s included
One shock absorber, part 324506.
Not included: the dust boot.










