Overview
The Pro Comp 55400 is a pair of boxed rear lower control arms for the Jeep Wrangler LJ and TJ. The boxed construction adds weld area around the bushing eyelet for improved strength where the arm carries the axle load. The part is the rear lower position, sold as a pair, with part number EXP55400.
The rear arms can be mounted bend down or upside down, and the upside down option can improve break-over angle. The arms fit the 2004-2006 Jeep Wrangler LJ and the 1997-2006 Jeep Wrangler TJ in the trims named in the fitment section.
Key features
- Boxed design with extra weld area around the bushing eyelet
- Rear lower position
- Sold as a pair
- Mount bend down or upside down for improved break-over angle
- Direct-fit design for the listed Wrangler models
Break-over and mounting direction
Break-over angle is the point where the underside of the vehicle can contact the ground on a crest. Changing how the lower control arm is mounted alters that clearance, so the choice between bend down and upside down depends on how much ground clearance matters on your trail. Rear arms carry axle and drive loads, so the mounting choice should be made before the bushings are fully tightened.
Pinion angle is affected by rear arm changes. When arm length, direction or bushing position changes, the pinion can move out of its set angle, which can lead to vibration and drivetrain wear. Measure the pinion angle after the install and correct it if needed.
Related parts are often checked at the same time. Bump stops, track bars and sway bar links are commonly inspected when rear arms are replaced, because axle position and suspension travel change with the arms.
- Set the bend direction before tightening bushings
- Measure pinion angle after the install
- Check bump stops and track bar bushings
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 55400 |
| Listed part code | EXP55400 |
| UPC | 614901114782 |
| Position | Rear lower |
| Design | Boxed lower control arm |
| Sold as | Pair |
| Fitment type | Direct fit |
Vehicle fitment
The 2004-2006 Jeep Wrangler LJ fits the Unlimited and Unlimited Rubicon trims. The 1997-2006 Jeep Wrangler TJ fits the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
Wrangler YJ, JK and JL models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rear lower arms carry the axle and the drive loads, so the install should be checked for bushing alignment and the pinion angle once the arms are set. The mounting direction changes the break-over angle, so decide on the bend direction before the arms are bolted in.
What’s included
The pair of boxed rear lower control arms is included. Check the parts list for bushings and mounting hardware before starting the install.










