Overview
The TeraFlex Long Arm Upgrade Kit, part number 1447780, adds Monster arms with 1.75 inch DOM tubing and control arm bracketry to an existing lift kit. The kit lists front and rear lower positions.
For a vehicle with more than 3 inch of lift, this kit is the better route as an upgrade to new Monster arms.
Key features
- Heavy duty Monster end assemblies
- 1.75 inch DOM arm tubing
- Control arm bracketry for straightforward installation
- Front and rear lower positions
Arm geometry after upgrading
Long arms hold the axle in a fixed fore-aft position, which helps control wrap and wander on a lifted Wrangler. Longer arms reduce the arm angle compared with short stock arms, so the bushings and end joints work through a smaller range. This can make the ride feel more controlled over washboard and rough trail sections.
Because the arm geometry changes, the rest of the front and rear suspension should be checked too. Track bars, shock mounts and brake lines may need inspection for clearance, and driveline angles should be measured after the install. Re-torque the arm hardware after the first few drives, and recheck the ends for play at regular service intervals.
- Check brake line and track bar clearance
- Inspect Monster end joints for play
- Re-torque arm fasteners after initial drives
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1447780 |
| UPC | 843885021469 |
| Arm tubing | 1.75 inch DOM |
| Ends | Monster end assemblies, heavy duty |
| Bracketry | Control arm bracketry included |
| Position | Front and rear lower |
| Installation | Drilling required |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler LJ (Unlimited and Unlimited Rubicon) and the 1997–2006 Jeep Wrangler TJ (65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X). Fit on other Wrangler models needs a year, model and trim match before buying.
Other generations, such as the JK and JL, are not covered. Match your vehicle’s year, model and trim to the kit before ordering.
Installation notes
Drilling is required, so plan for it before assembling the arms. After installation, have the alignment and driveline angles checked, as with any long arm conversion.
What’s included
Control arm bracketry and Monster end assemblies with 1.75 inch DOM arms.
Not included: an existing lift kit, which this upgrade is designed to build on.












