Overview
The Pro Comp PXA5161-893650 is an 18×9 aluminum split-spoke wheel from the Pro Comp 61 Series, finished in satin black milled and set up for a 6 on 135 bolt pattern. It is sold as one wheel, and its center bore of 87 is one of the figures to check first.
This 9-inch-wide wheel is low-pressure cast and carries a load rating in the 2500 to 3650 lbs per wheel range of the Pro Comp alloy line. It has an offset of 0 and a backspacing of 5. The six-lug 135 layout only fits a hub with six lug holes at that spacing.
Key features
- Low-pressure cast aluminum
- Split-spoke design
- 18-inch diameter, 9-inch width
- 6 on 135 bolt pattern
- Center bore of 87
- Zero offset and 5 backspacing
Six-lug hub considerations
Six-lug hubs show up on many trucks and SUVs, and the bolt pattern has to match exactly. Lug holes that are slightly off will not pull the wheel flat against the hub, even when the nuts look tight. Before mounting tires, measure the hub studs and confirm the pattern by test-fitting the bare wheel.
A center bore that is too small will not seat on the hub pilot, and one that is too large can let the wheel wobble. Hub-centric rings fill the gap between the bore and hub in some setups, so ask about them if the fit feels loose. Tighten lug nuts in a star pattern and re-check them after the first few drives.
- Check stud length against lug nut seat depth
- Confirm the pilot diameter before fitting
- Re-torque after the first trail runs
Specifications
| Brand | Pro Comp Alloy Wheels |
|---|---|
| Part number | PXA5161-893650 |
| Series | 61 Series |
| Style | Split spoke |
| Construction | Aluminum |
| Finish | Satin black milled |
| Diameter | 18 inches |
| Width | 9 inches |
| Bolt pattern | 6 on 135 |
| Center bore | 87 |
| Offset | 0 |
| Backspacing | 5 |
| Load rating | 2500 to 3650 lbs per wheel (Pro Comp alloy range) |
Vehicle fitment
No vehicle is named for this wheel. The universal fit label does not confirm a model. The 6 on 135 bolt pattern and 87 center bore have to match the hub of the truck or Jeep, and the zero offset needs a clearance check.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Six lug holes at 135 have to line up exactly with the hub, so a 6 on 5.5 hub will not take this wheel. The 87 center bore should seat on the hub pilot. Test-fit with the tire to check the caliper and suspension clearance.
What’s included
One 18×9 aluminum wheel. Confirm the lug hardware and center cap needed for your hub before ordering.











