Overview
The Pro Comp K1171BX is a 6-inch lift kit with PRO-VST front coilovers and PRO-VST rear shocks for the 2014–2018 Chevrolet Silverado 1500 and GMC Sierra 1500. It is a stage 1 lift with a lift height range of 6 to 7 inches, and both shocks come with the kit.
The rear uses a block-and-U-bolt lift with add-a-leaf hardware. Pro Comp’s notes say the 6-inch K1171B kit works on GM 1500 trucks with either aluminum or stamped steel control arms. Those control arms changed on April 1, 2016: trucks built before that date had cast steel or aluminum arms, and trucks built on or after it have stamped steel upper and lower arms.
Key features
- 6-inch stage 1 lift with a listed lift height range of 6 to 7 inches
- PRO-VST front coilovers and PRO-VST rear shocks, both included
- Block and U-bolt rear lift with add-a-leaf hardware
- The 6-inch K1171B works with both aluminum and stamped steel control arms.
- Fits the 2014–2018 Chevrolet Silverado 1500 and GMC Sierra 1500
Before you install
A front coilover and rear shock upgrade changes how the truck settles under load, so the new shocks should be checked after the first few drives. Look for leaks at the shock bodies and listen for knocking at the mounts. Lifting a truck also moves the suspension through a longer range of travel, which puts more strain on bushings, ball joints and tie rod ends. Inspecting these parts while the truck is on the lift is a sensible step before the kit goes on.
Block and U-bolt rear lifts depend on the axle staying square under the spring pack, so the U-bolts should be torqued after the first drive and checked again after a few weeks of use. Brake lines and the parking brake cable may need slack checks at the new ride height. On trucks with stamped steel control arms, the alignment shop should set caster carefully, since small changes there affect highway tracking.
- Re-check U-bolt torque after the first few drives
- Inspect brake lines and cables for stretch at the new height
- Replace worn tie rod ends and ball joints before lifting
- Keep the old shock mounting hardware for reference
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | K1171BX |
| Suspension type | Lift kit, stage 1 |
| Lift height | 6 inches, listed range 6–7 inches |
| Front shocks | PRO-VST coilovers |
| Rear shocks | PRO-VST, included |
| Rear lift method | Block and U-bolt with add-a-leaf |
| Shocks included | Yes |
Vehicle fitment
It fits the 2014–2018 Chevrolet Silverado 1500 and the 2014–2018 GMC Sierra 1500 across the trim levels covered for each truck.
It fits 2014–2018 Silverado 1500 and Sierra 1500 trucks only. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Lifting the truck changes driveline angles and steering geometry, so have the alignment checked and the driveline angles confirmed after installation. The older 6-inch K1165B and 4-inch K1159B kits, made for aluminum control arms, can use the 90-60616B sway bar bracket kit on trucks with stamped steel control arms. The K1171B-based kit does not need that bracket.
What’s included
PRO-VST front coilovers, PRO-VST rear shocks, and the rear block and U-bolt lift components with add-a-leaf hardware.





















