Overview
The G2 Axle and Gear Pinion Nut, part number 14-PN15, is the nut that threads onto the end of a differential pinion shaft. Tightening it clamps the pinion bearings and sets their preload, so torque is what controls the bearing setting.
It is identified by brand, part number and UPC. Confirm the thread size and torque against your carrier before installing.
Torque and preload basics
The pinion nut is the fastener that clamps the pinion bearings and sets their preload. Preload controls how the pinion turns inside the carrier, so the nut must be tightened to the carrier’s service value rather than by feel. Too little torque lets the bearings loosen, and too much can crush the bearing stack.
Inspect the pinion threads for damage before use, and clean any oil from the threads so the torque reading is accurate. Some service procedures call for a new nut each time, while others allow reuse, so follow the procedure for the carrier being rebuilt. Recheck preload after the first short drive.
- Clean the threads before tightening
- Use a torque wrench set to the service value
- Recheck preload after the first short drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 14-PN15 |
| UPC | 682034248469 |
| Part type | Pinion nut |
Vehicle fitment
Confirm fit for your carrier’s pinion thread before ordering, since the nut must match the shaft.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion nut torque sets bearing preload, so tighten it to the value given in your carrier’s service specifications with a torque wrench, then check preload. Use a new nut only if your service procedure calls for it.
What’s included
One pinion nut. Not included: the pinion yoke or flange, bearings and crush sleeve, which are separate items.








