Overview
The Omix-Ada Dana 30/44 pinion nut, part number 16584.01, is a replacement pinion nut for the Dana 30 and Dana 44 axle family. It is a direct OE replacement built to original specifications.
Pinion nut basics
The pinion nut holds the pinion gear in the carrier and sets the preload on the pinion bearings. Because preload matters, the nut should be tightened to the specified value rather than simply to feel, since a nut that loosens can let the gear move under load and damage the gear set.
Dana 30 and Dana 44 axles are common on older Jeep trucks and off-road builds, and many owners replace the pinion nut whenever they rebuild the front or rear differential. Pinion nuts are often replaced together with the pinion seal or a crush sleeve when those parts come out, since reusing a worn spacer can upset preload.
Inspect the nut threads, the pinion splines and the seal surface when the axle is opened. Look for stretched threads, a scored pinion shaft or an oil leak around the seal, which can point to a loose or worn nut.
- Replace the pinion seal when the nut is removed
- Measure preload during reassembly rather than tightening by feel
- Use a new crush sleeve if your axle uses one
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16584.01 |
| UPC | 804314013189 |
| Axle family | Dana 30/44 |
| Warranty | Limited five year warranty |
Vehicle fitment
It fits Jeeps with a Dana 300 transfer case. Confirm your year, model, trim and transfer case before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use your vehicle’s service specification for the torque value when installing the nut.








