Overview
The Crown Automotive J3182601 is a front pinion lock nut for AMC Model 20 and Dana 35 axles. It holds the pinion yoke on the pinion shaft and sets the bearing preload the gears depend on. It fits Jeep and Dodge vehicles from 1976 through 2018, including Cherokee, CJ, Comanche, Grand Cherokee, Liberty and Wrangler models.
Model 20 and Dana 35 are the two axle families this nut fits. Check the axle type on your vehicle before ordering, because the same model names appear across several axle families.
Key features
- Pinion lock nut for AMC Model 20 and Dana 35 axles
- Front position, direct-fit application
- Covers Jeep CJ, Cherokee, Wrangler (YJ, TJ, LJ and JK) and Grand Cherokee models, plus the 2007–2011 Dodge Nitro
- Crown part number J3182601
Setting pinion preload
The pinion nut does more than hold the yoke. It clamps the pinion bearings and sets the preload that keeps the ring and pinion running at the correct mesh. Too little preload lets the pinion move under load and can chatter the gears, while too much heats the bearings and shortens their life. Preload is set by feel and measurement, not by torque alone, so the nut should be tightened in small steps while the bearing turns.
Because the nut is part of a torque-critical assembly, always replace it rather than reusing an old one, and keep the threads and the yoke seat clean. Once the preload is set, check the pinion for play and the bearings for smooth rotation before the cover goes back on. Fluid level and gear oil quality also matter, since the bearings rely on them.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3182601 |
| UPC | 848399058536 |
| Axle | AMC Model 20 and Dana 35 |
| Position | Front |
| Fitment type | Direct fit |
Vehicle fitment
This lock nut fits the following vehicles:
- 1976–1983 Jeep CJ5
- 1976–1986 Jeep CJ7 and J10
- 1981–1985 Jeep Scrambler
- 1984–2001 Jeep Cherokee (XJ)
- 1986–1992 Jeep Comanche
- 1993–1998 Jeep Grand Cherokee (ZJ)
- 1999–2004 Jeep Grand Cherokee (WJ)
- 2002–2012 Jeep Liberty (KJ)
- 1988–1995 Jeep Wrangler (YJ)
- 1997–2006 Jeep Wrangler (TJ)
- 2004–2006 Jeep Wrangler Unlimited (LJ)
- 2007–2018 Jeep Wrangler (JK)
- 2007–2011 Dodge Nitro
The Wrangler (JL) and Grand Cherokee (WK) are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion nut tightening sets bearing preload, so use the axle’s service specification for torque and preload when the pinion is reassembled.
What’s included
One pinion lock nut, part number J3182601. No other hardware is named.








