Overview
The Oracle Lighting Universal Illuminated LED ‘A’ Letter Badge (matte black, part 3141-A-001) is a single edge-lit letter for building a custom glowing vehicle badge. Each letter lights up with a soft edge glow, and the housing keeps a clean look when the light is off. The letter is designed for DIY builds, so you choose the letters you need. Every letter in this range is the same overall size, so letters can be spaced evenly across a badge.
The letter draws less than 0.1 amp and measures approximately 3.75 inches wide, 1.4 inches tall and 0.5 inch thick. It mounts with VHB double-stick adhesive, and Oracle recommends its VHB primer, part 2082-504, for a stronger bond. The letter runs from a 12V source, such as the parking lights, an ignition fuse or a separate toggle switch.
The letter is a universal fit for cars, and its matte black finish matches the other letters in the range.
Key features
- Edge-lit soft glow when on
- Sleek housing with a high-end look when off
- Draw of less than 0.1 amp per letter
- VHB double-stick adhesive mount
- 12V operation from parking lights, an ignition fuse or a toggle switch
- Matte black finish
Layout and spacing tips
A custom badge depends on careful layout before any adhesive touches the paint. Lay the letters out on the surface with painter’s tape, check spacing from the edges of the panel, and look at the layout in daylight and at night before committing. Edge-lit letters can look uneven if one sits slightly higher than the rest, so keep the tops level across the whole badge.
Plan the wire route for each letter. Where a letter is mounted on a panel, the wire may need a small hole, which should be sealed and fitted with a grommet. Clean the surface with alcohol and let it dry fully. Warm the panel slightly before pressing the adhesive, since VHB bonds more firmly on a clean, warm surface, and keep the wire loose to avoid tugging the letter.
- Lay out letters with painter’s tape first
- Keep letter tops level across the badge
- Seal any hole used for the wire
- Test the glow at night before final mounting
Specifications
| Brand | Oracle Lighting |
|---|---|
| Part number | 3141-A-001 |
| Letter | A |
| Finish | Matte black |
| Size | Approximately 3.75 in wide, 1.4 in tall, 0.5 in thick |
| Current | Less than 0.1 amp per letter |
| Voltage | 12V |
| Mounting | VHB double-stick adhesive |
| Primer | VHB Primer, Oracle part 2082-504 |
Vehicle fitment
These letters are universal accessories, not built for one vehicle. Oracle lists them as universal fit for cars. Because the letter is glued in place, check the mounting surface and where the wire will route before pressing the adhesive down.
Installation notes
Clean the mounting surface and apply Oracle’s VHB primer for a stronger bond. A hole may be needed to route the wire, and each vehicle’s needs will be different, so plan the route before installing the letter.
What’s included
One illuminated LED letter “A” in matte black, with its wire and VHB double-stick adhesive.














