Overview
The Omix-ADA 16714.08 is a rear wheel stud. It fits the Cherokee (XJ), Grand Cherokee (ZJ), Wrangler (YJ) and Wrangler (TJ) across several generations.
It carries part number 16714.08 and UPC 804314061807. Because it fits several generations, match your model year and chassis before fitting.
Key features
- Rear position
- Fitment across XJ, ZJ, YJ and TJ generations
- Part number 16714.08
- Omix-ADA brand
Rear axle stud basics
The rear wheel stud sits in the hub flange and holds the wheel against the hub every time the vehicle moves, so it takes repeated load from braking and trail bumps. Across several generations, the hub and axle design can differ, which is why matching the model year and chassis matters as much as the stud itself. Rear studs on older Jeeps often show rust where moisture collects behind the wheel, so look at the base of each stud when rotating tires.
If one stud is damaged, check its neighbors at the same time, since they carry the same load and often show the same wear. Use a stud that matches the position and fitment for your vehicle, and avoid mixing studs from different sources in one hub. Lug nuts should seat cleanly on the stud taper, and a worn or mismatched nut can make the wheel feel loose even when the stud is fine. Inspect the set regularly and replace any stud that is cracked or bent.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16714.08 |
| UPC | 804314061807 |
| Position | Rear |
Vehicle fitment
It fits the 1984–1998 Jeep Cherokee (XJ), the 1993 Jeep Grand Cherokee (ZJ) (Base), the 1997–2000 Jeep Wrangler (TJ) (SE, Sahara, Sport) and the 1990–1995 Jeep Wrangler (YJ).
The list spans several generations, so do not assume a model year outside its entries fits. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Confirm the included parts against your installation before starting.









