Overview
The Crown Automotive 52000601 is a long tie rod end, the long side part, for the 1984–1990 Jeep Cherokee (XJ) in Base, Chief, Laredo, Limited, Pioneer and Sport trims. It is a direct fit, and the UPC is 848399012422.
Key features
- Long side design
- Direct fit shown for the 1984–1990 XJ
- Crown Automotive part number 52000601
- Six XJ trims covered by the list
Long tie rods on the XJ
The long tie rod end forms part of the steering linkage that carries movement between the steering gear and the wheels. On the Cherokee XJ, wear in these joints usually shows up as looseness, wandering on the highway or uneven tire wear across the front. Because the joint is under constant load, its boot and grease condition matter as much as its general wear.
When replacing a long tie rod end, compare its position and thread direction with the end you are removing, and check that the mounting hole and nut fit the tie rod correctly. Inspect the other steering joints while the front is apart, including the short tie rod end and drag link, because a loose partner can make a new joint feel unsettled. Finish with a front alignment, since changing a tie rod end affects toe.
- Compare position and thread direction
- Check the boot for cracks
- Inspect the other steering joints
- Set toe after installation
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52000601 |
| UPC | 848399012422 |
| Part type | Long tie rod end |
| Design | Long side |
Vehicle fitment
It fits the 1984–1990 Jeep Cherokee (XJ) in Base, Chief, Laredo, Limited, Pioneer and Sport trims.
The list covers Cherokee XJ years only, not the Wrangler YJ or Grand Cherokee models. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One long tie rod end is included. Confirm its position and thread direction against the part you are replacing before installing it.









