Overview
It is an inner tie rod end with a right hand thread. It fits a range of Jeep CJ and Willys models, from the CJ-2 through the CJ-7 and the Scrambler.
The inner position means this end sits on the inboard side of the tie rod assembly. Its right hand thread is the detail to match before the old end comes off.
Key features
- Inner position
- Right hand thread
- Thread direction check recommended before ordering
- Direct fit listing covering ten Jeep and Willys entries
Inner joints and steering play
The inner tie rod end sits closer to the center of the steering linkage and connects to the center link or steering gear arm. Because it sits inboard, it is harder to inspect and tends to wear without obvious signs until steering play becomes noticeable. Check it by grasping the tie rod near the center link and feeling for movement while someone turns the wheel.
Replacing an inner end usually requires checking the outer ends and the center link too. Once the new part is installed, have the steering checked for play and the front alignment reset. Keep the boot clean and free of grit to slow future wear.
- Check for play at the center link
- Inspect the outer ends as well
- Reset alignment after the swap
- Keep the boot clean and intact
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18043.04 |
| UPC | 804314048754 |
| Position | Inner |
| Thread direction | Right hand |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1959-1960 Jeep CJ3, the 1959-1960 and 1968-1983 Jeep CJ5, the 1959-1960 and 1968-1975 Jeep CJ6, the 1976-1986 Jeep CJ7, the 1981-1985 Jeep Scrambler, the 1946-1949 Willys CJ-2, the 1949-1958 Willys CJ-3, the 1955-1958 Willys CJ-5, the 1956-1958 Willys CJ-6 and the 1941-1942 Willys MB.
The CJ3 range covers 1959 and 1960 only, and the CJ5 and CJ6 ranges begin in 1968. Other years fall outside its fit, so confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Because this is an inner end, have the steering checked for play and the alignment reset after the swap.
What’s included
One inner tie rod end, part number 18043.04.
























