Overview
The Omix-Ada tie rod end, part number OAI18043.10, has a 7/8 inch thread diameter and left hand threads, and it attaches at the pitman arm. It fits the 1991–2001 Jeep Cherokee (XJ), 1993–1998 Jeep Grand Cherokee (ZJ), 1997–2006 Jeep Wrangler (TJ) and 1991–1995 Jeep Wrangler (YJ).
Tie rod ends keep the steering linkage aligned, and a worn one can cause premature tire wear. This is a 7/8-inch diameter end, so check the thread size and direction against the joint you are replacing.
Key features
- 7/8 inch thread diameter
- Left hand threads
- Attaches at the pitman arm
- Fits XJ, ZJ, TJ and YJ Jeep models
Tie rod wear and replacement
A tie rod end is a ball joint that carries steering force from the linkage to the wheel. Over time the joint wears, and play in the socket shows up as wandering on the road, a loose feel at the steering wheel or uneven tread wear on the front tires. Because the end is threaded into the tie rod, it is usually replaced as a unit, and the adjusting sleeve may need resetting once the new end is in place.
On an older Wrangler or Cherokee, the pitman arm end often sits near rust and road grime, so penetrating oil and a careful look at the threads help before removal. Left hand threads turn the opposite way from right hand threads, so mark the original position of the jam nut and count the turns when you unscrew it. After installation, have the front alignment checked, since a changed tie rod length moves the toe setting.
Re-torque the castle nut and cotter pin after the first few drives, and recheck the boot for tears. A torn boot lets grit into the joint and shortens its life.
- Play in the joint or a loose steering feel
- Torn boot or grease leak
- Uneven front tire wear
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI18043.10 |
| Thread diameter | 7/8 inch |
| Thread direction | Left hand |
| Location | At pitman arm |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1991–2001 Jeep Cherokee (XJ) in Base, Briarwood, Classic, Country, Laredo, Limited, SE and Sport trims; the 1993–1998 Jeep Grand Cherokee (ZJ) in 5.9 Limited, Base, Laredo, Limited, Orvis, SE and TSi trims; the 1997–2006 Jeep Wrangler (TJ) in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims; and the 1991–1995 Jeep Wrangler (YJ) in Base, Islander, Renegade, Rio Grande, S, SE and Sahara trims.
Fitment covers only the years and trims above. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Left hand threads run opposite to right hand threads, so check that the replacement matches the left hand thread of the tie rod end you remove before threading it on.
What’s included
The package contains one tie rod end.










