Overview
The Omix-ADA 16534.03 is an outer axle seal for the AMC Model 20 axle, made as a direct OE replacement. It fits the 1976–1983 Jeep CJ5, the 1976–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler.
Omix-ADA builds its replacement Jeep parts to original specifications, with a limited five year warranty. The outer position sits at the wheel end of the axle and keeps axle oil from leaking past the shaft.
Owners rebuilding a Model 20 should compare the seal against the old one before fitting.
Omix-ADA presents this seal as part of its OE-specification range for Jeeps, which suits restorations of CJ models where owners want original dimensions. Seals on both axle ends are often replaced as a pair.
The AMC Model 20 was the rear axle behind many CJ-series Jeeps, and Omix-ADA’s seal keeps to the original design. Original-spec seals are popular among owners who want a reliable factory fit instead of an upgrade.
Key features
- Outer axle seal for the AMC Model 20
- Direct OE replacement
- Built to original specifications.
- Backed by a limited five year warranty
- Outer position
- Covers CJ5, CJ7 and Scrambler
Inspecting the seal area
An outer axle seal works at the wheel end of the axle tube, holding axle oil in while the shaft turns. Because it is exposed to grit and road water, its lip can dry out or chip over time, and a leak often shows as oil on the brake backing plate or the inside of the wheel. Inspect the seal area each time the hub is opened.
When the shaft is out, check the bore and the shaft surface for grooves, rust or pitting, since a damaged surface will let oil pass even with a new seal. Clean the bore thoroughly and wipe the new seal’s lip with clean oil before pressing it in. Outer seals are often replaced alongside the bearings on CJ rebuilds, and a shaft with worn splines should be renewed at the same time.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16534.03 |
| UPC | 804314029623 |
| Product type | Outer axle seal |
| Axle | AMC Model 20 |
| Position | Outer |
| Warranty | Limited five year warranty |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Omix-Ada 16534.03 includes: 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade); 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade); 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR).
The CJ5 fits 1976–1983 only, along with the CJ7 and Scrambler. Earlier CJ5 years and the Wrangler YJ are not covered. Make sure the year, model and trim match before you order.
Installation notes
The seal sits at the outer end of the axle tube, so removing the axle shaft is part of the job. Inspect the shaft surface and the tube bore before pressing in a new seal.
What’s included
- One outer axle seal, part number 16534.03









