Overview
The Crown Automotive 52087716 is a rear lower control arm for the 1993–1998 Jeep Grand Cherokee (ZJ). It is positioned as the rear lower arm and is a direct fit for the ZJ trims shown below.
Check the arm’s bushings and included hardware against your current arm before installing it.
Key features
- Rear lower position
- Designed for 1993–1998 Grand Cherokee ZJ
- Crown part number 52087716 and UPC 848399015584
- It is a direct fit for the 1993–1998 Jeep Grand Cherokee ZJ.
Replacing the rear lower arm
The rear lower control arm holds the axle in place fore and aft and carries braking and acceleration loads into the frame. Because it works with the upper arm and the bushings, a worn arm can cause clunks over bumps, wandering on the road or uneven rear tire wear. Look for cracked welds, bent metal and bushings that are split, collapsed or leaking.
When choosing a replacement, confirm the position and side against the arm you are removing, and compare the mounting points before installing. Rear lower arms are often replaced in pairs so both sides wear and handle the same way. Keep the vehicle safely supported on stands during the swap. After installation, have the rear alignment checked, since changes to the arm’s length or mounting can shift toe and axle angle.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52087716 |
| UPC | 848399015584 |
| Position | Rear lower |
| Application | 1993–1998 Jeep Grand Cherokee (ZJ) |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1993–1998 Jeep Grand Cherokee ZJ models, including 5.9 Limited, Base, Laredo, Limited, Orvis, SE and TSi trims.
Other Grand Cherokee generations, such as the WJ (1999–2004), are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Confirm the bushings and hardware against your installation before starting.









