Overview
The Omix-Ada 17409.01 is an intake valve spring for Jeep Willys and Jeepster models. It fits 1946–1952 Willys vehicles and 1966–1969 Jeepster Base and Commando models.
It is a direct OE replacement built to original specifications, and it comes with a limited five year warranty from Omix-Ada.
Key features
- Direct OE replacement
- Built to original specifications
- Intake position
- Limited five year manufacturer warranty
Valve spring replacement
Valve springs hold the valves closed against the seats and keep them tracking properly as the cam lifts them. Over years of heat cycles and high rpm use, springs lose pressure, which can lead to valve float, poor idle and misfires. Springs are reached only with the cylinder head off, so replacing them is usually done during a valve service where the seats and guides are also checked.
When fitting a new spring, verify that the retainers, keepers and valve seals are in good condition, since a worn keeper can let a valve drop into the cylinder. Keep old and new springs separate so they can be compared, and avoid mixing springs of different age or pressure in the same head. A spring pressure check on the bench before assembly helps confirm the new parts match the rest of the valvetrain.
- Check the valve seats and guides during the same job
- Replace worn retainers and keepers with the springs
- Verify the valve seals before reassembly
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI17409.01 |
| Position | Intake |
| Engine types | L-head and F-head (per short description) |
| Warranty | Limited five year manufacturer warranty |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1946–1952 Jeep Willys CJ-2, CJ-3, 463, 473, FJ, Jeepster, M38, M38A1, Panel, Sedan Delivery, Truck and 1-Ton models, plus the 1966–1969 Jeepster.
Models and years outside these entries are not covered, including later CJ models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Valve springs are reached with the cylinder head off, so this job usually goes with a valve service. Disconnect the battery before starting engine work.
What’s included
It is one intake valve spring.
Not included: Check retainers, keepers and valve seals against your installation before starting.









