Overview
The Omix-Ada 18880.27 is a T90 reverse idler shaft plate and a direct OE replacement for Willys and Jeep vehicles from 1946 to 1971. It is built to original specifications.
It fits many CJ, Willys, Jeepster, FC, J-series, Wagoneer and Gladiator models, from the early CJ-2 and CJ-3 through the 1971 J-4800. Use the vehicle fitment section below to check your model and year.
Key features
- T90 reverse idler shaft plate for the listed Jeep and Willys models
- Direct OE replacement built to original specifications
- Covered by a limited five year warranty from Omix-Ada.
- Omix-Ada part number 18880.27 with UPC 804314017873
- Covers many CJ, Willys, Jeepster, FC and J-series models from 1946 to 1971
Reverse idler plate wear
The reverse idler shaft plate supports a shaft that carries the reverse idler gear, so it takes steady load each time reverse is selected. Over years of use, the bore that holds the shaft can wear oval, and the plate can develop cracks near the bolt holes. Older Jeep transmissions in the CJ and Willys range often show this wear, which can make reverse hard to find or cause noise.
Because the plate sits inside the case, inspecting it means removing the side cover or fully disassembling the unit. Look at the bore for scoring, check the gear teeth and bearings nearby, and replace any worn gaskets at the same time. Clean the case face carefully so the new plate seats flat.
- Look for an oval or scored shaft bore
- Check reverse idler gear teeth for chips
- Replace gaskets whenever the cover comes off
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18880.27 |
| UPC | 804314017873 |
| Application | T90 reverse idler shaft plate |
| Fitment type | Direct OE replacement |
| Warranty | Omix-Ada backs it with a limited five year warranty. |
| Model years in fitment list | 1946-1971 |
Vehicle fitment
The manufacturer fitment list includes these base-trim models: CJ-2, CJ-3, CJ-5 and CJ-6, DJ-3 and DJ-6, Commando, Jeepster, FC150 and FC170, Gladiator, J-100 through J-4800 trucks, Tornado, Utility, Universal, Wagoneer (SJ), and Willys 1-Ton, Panel, Sedan Delivery and Utility Wagon models. Model years vary by model within 1946 to 1971.
Years outside 1946 to 1971, and models not named here, such as later CJ models, are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A reverse idler shaft plate is serviced inside the transmission, so this job is best handled by a shop with manual transmission experience. Match the part number 18880.27 to the original plate before disassembly.
What’s included
Gather any bolts or gaskets the job needs before starting.









