Overview
The Omix-ADA 16526.01 is an inner axle seal for the full floating type rear Dana 27, and for front Dana 25 and Dana 27 models. It fits the 1941–1942 Willys MB.
Omix-ADA builds its Jeep range as direct OE replacement parts to original specifications, with a limited five year warranty. This seal fits the rear inner position, where a full floating axle seal keeps gear oil inside the housing.
Confirm the axle and position on your vehicle before ordering, since the seal covers a rear Dana 27 and front Dana 25 and 27 models.
The Willys MB is the only vehicle this seal fits. Owners restoring an MB should compare the seal with their own axle, noting the Dana 27 and full floating rear arrangement.
A full floating rear axle carries the vehicle’s weight on the axle housing instead of the shaft, and the inner seal at the differential end still has to hold gear oil in.
Omix-ADA gives the position as rear inner and the type as full floating, which are the two details to compare with the old seal’s size and lip direction.
Key features
- Inner axle seal
- Full floating type rear Dana 27
- Also for front Dana 25 and 27 models
- Rear inner position
- Fits the 1941 to 1942 Willys MB
- Limited five year warranty from Omix-ADA
Before fitting the seal
An inner axle seal sits where the axle shaft enters the differential housing, and its job is to keep gear oil from running out along the shaft. On a full floating rear, the shaft carries no vehicle weight, so the seal is the main barrier between the oil and the brake area. Before removing the old seal, drain the housing, clean the bore and look for scoring on the shaft where the lip rides.
Seal lips harden with age and heat, and a small groove in the shaft will let oil pass even on a new seal. Replacing the seal with the shaft still in place is common, but a pitted or grooved shaft should be renewed too. Pack the lip lightly with clean gear oil so it is not run dry on first start-up, and check the housing for cracks around the bore before the cover goes back on.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16526.01 |
| UPC | 804314068363 |
| Part type | Inner axle seal |
| Axle | Full floating rear Dana 27; front Dana 25 and 27 models |
| Position | Rear inner |
| Warranty | Limited five year warranty |
| Fitment type | Direct fit |
Vehicle fitment
The 16526.01 inner axle seal fits this vehicle:
- 1941–1942 Willys MB (Base)
It fits the 1941–1942 Willys MB only. Later Jeep models are not covered by this part. Confirm your year, model and trim before you order.
Installation notes
Both a full floating rear Dana 27 and front 25 and 27 models are named, so confirm which axle and position you are working on before fitting the seal.









