Select your vehicle

Dana Spicer Dana 50 Inner Axle Seal – 40710

Dana Spicer

$12.12In stock
Buy on Amazon

See similar parts on Amazon

Price and availability as of Nov 18, 2026 5:40 AM MST, from Amazon.com, and subject to change. The Amazon listing has the current details.

Check out with your Amazon account. Amazon handles delivery and returns.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Dana Spicer 40710 front inner axle seal for Dana 50 axles
  • Universal fit listed; no vehicle named
  • UPC 23913140151

Description

Overview

The Dana Spicer 40710 is a front inner axle seal for Dana 50 axles. It seals the axle housing to the shaft, helping keep gear oil from leaking out of the axle tubes.

It is universal fit for the front Dana 50 axle type. Match the seal to your axle before fitting, since fit is set by axle type rather than by vehicle.

Key features

  • Front axle position
  • Dana 50 axle type
  • Seals the axle housing to the shaft
  • Helps keep gear oil in the axle tubes

Before you rebuild the axle

The inner axle seal sits where the shaft leaves the axle tube, so its job is to keep gear oil inside the housing while the shaft turns. Over time the sealing lip can harden, wear or pick up grit, and a small leak often starts there before anything else shows. Because the seal is pressed into the housing, it is usually easiest to replace while the axle is already open for bearing or gasket work.

Before fitting, clean the bore and check it for scoring or rust that could let oil bypass the outside edge of the seal. Inspect the shaft surface where the lip rides, and smooth any burrs with a fine stone. Pack the lip lightly with fresh gear oil so it does not run dry on first start-up. A new seal alone will not fix a leak caused by a worn bearing or a cracked housing, so look for those too.

Specifications

Brand Dana Spicer
Part number 40710
UPC 23913140151
Axle location Front
Axle type Dana 50
Fitment Universal fit

Vehicle fitment

No vehicle is named for this seal. Fitment is universal and tied to the front Dana 50 axle type, so check the axle rather than a model year.

Confirm your vehicle’s year, model and trim before ordering.

What’s included

One front seal for a Dana 50 axle is included.

SKU: D/S40710 Category:

Specification

Shipping weight 0.15 lbs
Package dimensions 3.30 × 3.30 × 1.90 in
brands

Questions & Answers

Is 40710 a front or rear seal?

It is a front seal for the Dana 50 axle, with the axle location set to Front. It is not intended for a rear axle.

Which axle type does this seal suit?

It is for the Dana 50 axle type and carries a universal fit label. No year, make, model or chassis code applies, so confirm the axle before fitting the seal to your vehicle.

What are the UPC and part number?

The part number is 40710 and the UPC is 23913140151. Use both to confirm the seal matches your Dana 50 front axle before you start the rebuild.

Should the inner seal be replaced during a bearing service?

Usually, yes. A seal that has been pulled out often has a nicked sealing lip, so reusing it is risky. Replacing it while the axle is open is a practical step that avoids a second teardown.

What signs show the inner seal is leaking?

Gear oil on the inside of the wheel, on brake parts or along the axle tube usually points to a leaking inner seal. Check the seal area after a drive and look for dried oil streaks.

Ready to order?

Order this part on Amazon and check out with your Amazon account. Amazon handles delivery and returns.

Buy on Amazon