Overview
The Omix-ADA 16534.13 is an axle shaft seal for the Dana 30 front axle on 2007–2010 Jeep Wrangler JK models, both 2-door and 4-door. It is for the driver or passenger side and is a direct OE replacement built to the original Jeep specifications.
The seal is a single part number for the 2007 to 2010 Jeep Wrangler JK. Confirm which side of your Wrangler needs it before ordering, since each side takes its own seal.
Key features
- Direct OE replacement built to original Jeep specifications
- For 2-door and 4-door Wrangler JK models
- Fits the Dana 30 front axle
- Driver or passenger side
- Covered by a limited five-year warranty
Seal replacement basics
An axle shaft seal sits between the axle tube and the shaft at the hub end, keeping gear oil in and water and grit out. On a Dana 30 front, the seal runs against the shaft every time the wheel turns, so its lip wears gradually. Replacing the seal before it starts leaking protects the bearings and the hub area from oil contamination.
Before pressing in a new seal, remove the old one carefully so the bore is not scratched, and clean the seating area. Check the shaft where the lip rides for grooves or rust, because a damaged surface will ruin a fresh seal quickly. Pack the lip lightly with grease, drive the seal in square, and recheck the axle oil level after the first few trips.
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16534.13 |
| UPC | 804314030186 |
| Axle | Dana 30 front |
| Position | Driver or passenger side |
| Body style | 2-door and 4-door models |
| Warranty | Limited five-year warranty |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007 to 2010 Jeep Wrangler JK, with the Dana 30 front axle as the application.
Close vehicles that are not on the list include Wrangler JK models from 2011 to 2018 and the Wrangler JL, along with TJ and LJ Wranglers. Confirm your vehicle’s year, model and trim before ordering.
What’s included
This is one axle shaft seal for either the driver or passenger side. Check the package contents against your installation before starting.












