Overview
The Omix-ADA glove box latch bracket, part number 13317.01, is a replacement latch bracket for a non-locking glove box door. It is a direct OE replacement Jeep part built to original specifications.
Confirm the bracket’s fit for your Jeep’s year, model and trim before ordering.
Key features
- Designed for a non-locking glove box door
- Direct OE replacement built to original specifications
- It is a direct fit part.
- Covered by a limited five year warranty.
Latch wear and glove box doors
A glove box latch holds the door closed under the weight of the lid and anything stored behind it. Over time the bracket and its pivot points can wear, leaving the door to rattle or pop open on rough roads. A worn bracket also strains the latch spring and the door hinge, so the cause is often found by checking the whole assembly rather than the latch alone.
When replacing the part, check how the door closes before removing the old piece. Note the alignment and the position of any spring, because a misaligned bracket can stop the latch from catching. Glove box hardware is usually small and inexpensive, so replacing the whole latch assembly is common when a bracket is cracked.
- Look for cracks or bent tabs at the mounting points
- Check that the latch catches firmly when the door closes
- Inspect the hinge and door for sag
- Clean the striker area before reinstalling
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 13317.01 |
| UPC | 804314020088 |
| Door type | Non-locking glove box door |
| Warranty | Limited five year warranty |
Vehicle fitment
Match the bracket to your Jeep’s year and model before buying, and check it against your current latch and door.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents for included hardware before installing the bracket.









