Overview
The Omix-ADA 16560.62 is a front hub bolt with a 12-point head for the 2007–2018 Jeep Wrangler JK and JKU and the 1999–2004 Jeep Grand Cherokee WJ with a Dana 30 front differential.
The hub bolt secures the hub to the steering knuckle. It is an OE quality replacement for OE 5012436AB and has the correct 12-point head.
The bolt is sold individually and a vehicle requires three per side, six in total. Omix-ADA’s notes cover 2-door and 4-door Wrangler JK models and the Grand Cherokee WJ.
Dana 30 front axles were used on a range of Jeeps, so fitment depends on both vehicle and axle: the 2007–2018 Wrangler JK and JKU and the 1999–2004 Grand Cherokee WJ with Dana 30 front differentials. If the axle has been swapped, identify the axle itself rather than relying on the model name. Confirm bolt length and thread against the old fastener, using the 12-point head and OE number 5012436AB as references.
Key features
- Secures the hub to the steering knuckle
- 12-point head
- For Dana 30 front axles
- Replaces OE 5012436AB
- Sold individually, three per side
- Fits two and four door Wrangler JK models
Torque and retightening
A hub bolt holds its clamp load through stretch, so the torque it was installed at matters as much as the bolt itself. Use a torque wrench set to the factory value from the service manual, and avoid impact tools for the final tightening. A 12-point head needs a socket that seats fully, since a rounded head makes accurate torque difficult to reach.
After the first few drives, recheck the torque and look for movement, clicking or heat at the hub. Inspect old fasteners for thread damage, a necked-down shank or rounded head corners. Those signs point to a bolt that should be replaced rather than reused.
- Use a socket that fully seats the 12-point head
- Clean threads before applying torque
- Recheck torque after the first few drives
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16560.62 |
| UPC | 804314302603 |
| Part type | Front hub bolt |
| Head type | 12-point |
| Axle | Dana 30 front |
| Replaces OE part | 5012436AB |
| Quantity needed | 3 per side, 6 per vehicle |
| Sold as | Individual bolt |
Vehicle fitment
Omix-ADA names these vehicles and trims for the 16560.62 hub bolt:
- 1999–2004 Jeep Grand Cherokee (WJ) (Laredo, Limited, Overland, Special Edition, Sport)
- 2007–2018 Jeep Wrangler (JK) (70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S, Unlimited 70th Anniversary, Unlimited 75th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited Sport S, Unlimited X, X)
Only the Wrangler JK and Grand Cherokee WJ are listed, and the bolt is meant for models with a Dana 30 front differential. The Wrangler TJ, LJ and YJ and the Grand Cherokee ZJ are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Order six for a complete set, because a single bolt is supplied. The 12-point head needs a matching socket, and the factory torque figure for your vehicle should be used.
What’s included
One bolt, part number 16560.62.
Not included: the other bolts for a full set, bearings and seals.












