Overview
The Omix-ADA 16749.13 is a rear brake caliper bracket for the 2008–2012 Jeep Liberty and 2007–2018 Jeep Wrangler. It fits both the left and right rear calipers and is sold individually.
A damaged caliper bracket can keep a brake caliper from sitting square on the rotor. The part is a direct fit for either the driver or passenger rear position, so the same part number serves either side. It fits both 2-door and 4-door models. Replacing a rear bracket is a good time to inspect the rear pads, rotors and caliper slides on that side. Since one part number fits either side, replacing a pair means ordering the same number twice.
Key features
- Rear brake caliper bracket
- Fits driver or passenger side rear
- Sold individually
- Fits 2-door and 4-door models
- Direct fit listing for Jeep Liberty and Wrangler
Rear caliper bracket checks
The caliper bracket holds the caliper in position over the rotor and gives the caliper its mounting surface. If it cracks, bends or wears at the mounting face, the caliper can sit off-square, and uneven pad wear or noise can follow. A bracket that is damaged should be replaced rather than straightened or repaired.
Before fitting a new bracket, clean the mounting face and the caliper slide area so the parts seat flat. Check the bolt holes for damage and use new hardware where the old bolts are stretched or corroded. Rear brake work can also involve the parking brake, so confirm its operation after the job is complete.
- Inspect the mounting face for cracks or wear
- Clean the caliper slide area before assembly
- Test the parking brake after finishing the work
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16749.13 |
| UPC | 804314279691 |
| Part type | Caliper bracket |
| Position | Rear |
| Side | Driver or passenger side rear |
| Body styles | 2 and 4-door models |
| Sold as | Individually |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2008–2012 Jeep Liberty and the 2007–2018 Jeep Wrangler. The Wrangler range covers the JK generation from 2007 through 2018, and both models share rear brake hardware in these years.
Other Liberty years are not covered, and the Wrangler JL and older Wranglers do not fit. The bracket is for the rear position only. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The bracket is sold individually, so order one for each rear side you plan to service. Install it with the correct caliper bolts and follow the Jeep service procedure for the tightening specification. Clean the mounting face and caliper slide area before assembly so the caliper moves freely, and replace any damaged hardware at the same time.
What’s included
- One caliper bracket, part 16749.13, sold individually
Not included: a second bracket for the opposite side, the brake caliper, mounting bolts or brake pads.












