Overview
The Omix-ADA 16534.14 is an axle shaft seal for the rear Dana 35 and Dana 44 axles on 2 and 4 door models. It fits the driver or passenger side and fits the 2007 to 2011 and 2013 to 2017 Jeep Wrangler JK.
The shaft seal keeps lubricant in the rear axle housing where the axle shaft passes through it, and it is written for both sides of the axle.
Signs the seal is failing
A failing axle shaft seal usually shows up as lubricant seeping onto the inside of the wheel or along the brake backing plate. Gear oil that reaches the brakes can reduce stopping power, so a leak at this point needs prompt attention rather than a top-off. Look for dark, wet film around the axle flange after a drive.
Seal lips harden and crack with age, and a worn bearing can push grease past a tired seal. When the axle is open, inspect the bearing and retainer area, because a new seal will not last long on a damaged bearing. Clean the axle housing before fitting the new seal so no grit gets under the lip.
- Oil on the inside of the wheel
- Gear oil on the brake backing plate
- Hardened or grooved seal lip
- Rough or noisy bearing on removal
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16534.14 |
| UPC | 804314169930 |
| Axle | Dana 35 and Dana 44 rear |
| Side | Driver or passenger |
| Body style | 2 and 4 door models |
Vehicle fitment
It fits the 2007 to 2011 and 2013 to 2017 Jeep Wrangler JK, in the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Unlimited Rubicon and Unlimited X trims.
The 2012 Wrangler JK year is not in the list, so check that year before ordering. The Wrangler TJ, YJ and LJ are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One axle shaft seal. No bearing or retainer is included.









