Overview
The Omix-ADA 16560.61 is a hub-bearing to knuckle bolt for the 1987–1995 Jeep Wrangler YJ and 1997–2006 Wrangler TJ, used to mount the front unit bearing to the steering knuckle.
Omix-ADA says its replacement parts meet or exceed OE standards. This bolt replaces OE number 34201535 and is sold individually, so a vehicle needs six, three on each side.
It fits 1987 to 2006 Wrangler, Rubicon and Unlimited models, including the 2004–2006 Wrangler Unlimited (LJ).
The unit bearing on these Wranglers bolts to the knuckle, so the three bolts on each side hold the front hub bearing in place. Confirm length, thread and grade against the OE cross-reference 34201535 before installing. Rubicon and Unlimited models are covered alongside the standard Wrangler. Buying six covers both front wheel ends in one job.
Key features
- Mounts the front unit bearing to the steering knuckle
- Replaces OE 34201535
- Sold individually
- Six bolts per vehicle, three per side
- Direct fit
- Designed to meet or exceed OE standards
Front hub bearing basics
A hub-bearing bolt clamps the front hub bearing to the steering knuckle, so its job is to hold that assembly steady under load. A loose or stretched bolt can cause wheel wobble, a clicking or knocking noise, or heat at the hub after a drive. Because the bolts work together, a problem in one often shows up as wear on the others.
When installing new bolts, clean the threads and bolt holes and check the knuckle face for damage or debris. Tighten to the factory torque and recheck after the first few drives. Replacing the full set on one wheel end at the same time is a common approach, since a worn bolt can leave the rest carrying extra load.
- Clean threads and holes before fitting
- Check the knuckle face for damage
- Recheck torque after the first drives
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16560.61 |
| UPC | 804314293741 |
| Part type | Hub-bearing to knuckle bolt |
| Replaces OE part | 34201535 |
| Sold as | Individual bolt |
| Quantity needed | 6 per vehicle (3 per side) |
Vehicle fitment
It fits three Wrangler generations:
- 2004–2006 Jeep Wrangler (LJ) (Unlimited, Unlimited Rubicon)
- 1997–2006 Jeep Wrangler (TJ) (65th Anniversary Edition, Rubicon, SE, Sahara, Sport, X)
- 1987–1995 Jeep Wrangler (YJ) (Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara, Sport)
Only the Wrangler YJ, TJ and LJ are listed. The Wrangler JK and the Cherokee, Comanche and Grand Cherokee models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Since the bolt comes singly, buy enough for the job: six restores both front wheel ends. Use the torque value in the factory manual for your Wrangler, as Omix-ADA gives none.
What’s included
One bolt, part number 16560.61.
Not included: the five additional bolts needed for a complete vehicle set, bearings and seals.














