Overview
The Omix-Ada engine oil pan gasket, part number OAI17439.15, seals the oil pan on 2007-2011 Jeep Wrangler JK and JKU models with 3.8-liter engines that use coil-on-plug ignition.
It is a factory-style replacement and a direct replacement for the original, and it replaces OE 4448896AB. It fits both 2-door and 4-door Wranglers, including the Unlimited models.
Key features
- Factory-style replacement engine oil pan gasket
- Direct replacement for OE number 4448896AB
- Made for 3.8-liter engines with coil-on-plug ignition
- Fits 2-door and 4-door 2007-2011 Wrangler JK models
Sealing the oil pan well
The oil pan gasket is the seal between the pan and the engine block, so it sees oil pressure and heat every time the engine runs. Leaks usually start at the corners or along the seam, and a seal that is hardened or flattened will weep even when the bolts are tight.
Before fitting a new gasket, clean the pan and block surfaces and remove any old gasket material. Set the gasket in place dry, and tighten the pan bolts gradually so the seal compresses evenly. Refill with fresh oil and check for leaks after a short run.
- Clean both sealing surfaces fully
- Check the corners and seam for old residue
- Tighten pan bolts gradually and evenly
- Check for leaks after a short warm run
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI17439.15 |
| OE replacement number | 4448896AB |
| Part type | Engine oil pan gasket |
| Engine | 3.8-liter V6 with coil-on-plug ignition |
| Body styles | 2-door and 4-door |
Vehicle fitment
The manufacturer fitment list covers 2007-2011 Jeep Wrangler (JK) in the 70th Anniversary, Rubicon, Sahara, Sport and X trims, plus the Unlimited 70th Anniversary, Rubicon, Sahara, Sport and X trims.
Later JK years and the JL are not covered, and earlier TJ and LJ Wranglers are not covered either. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing an oil pan gasket means draining the engine oil and removing the pan, so have fresh oil and a filter ready. Clean both sealing surfaces before setting the new gasket in place. Work under a raised vehicle only on secure jack stands.
What’s included
One engine oil pan gasket. Fresh oil, a filter and sealant are needed separately for the job.










