Overview
The Omix-Ada 16509.22 is a Dana 44 axle bearing and cup, sold as a direct OE replacement for early Jeep CJ, Grand Cherokee ZJ and Wrangler models. Omix-Ada builds its parts to the original specifications.
Covers the 1970-1975 CJ5, the 1986 CJ7, the 1993-1998 Grand Cherokee (ZJ), the 2004-2006 Wrangler (LJ), the 1997-2006 Wrangler (TJ) and the 2007-2011 Wrangler (JK). Rubicon models need a closer trim check.
Key features
- Direct OE replacement built to original specifications
- Dana 44 axle bearing and cup
- Rubicon trims need a fit check
- Covered by a limited five-year warranty
Bearing and cup replacement
Axle bearings and cups are a matched pair. The cup is pressed into the housing and the bearing rides inside it, so replacing one without the other usually leads to uneven wear. Bearing noise that changes with speed, looseness at the wheel, or heat near the hub are common signs the set is worn and due for service.
When replacing a bearing and cup, inspect the seal, the axle shaft and the housing bore for scoring or wear. Clean the bore thoroughly and use the correct installation tool so the cup seats square. Setting bearing preload correctly is important, and it is often done along with seal replacement. Keep the old parts for comparison until the new set is installed.
- Replace the seal when the bearing is removed
- Check the bore for scoring before pressing in the cup
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16509.22 |
| UPC | 804314040680 |
| Axle | Dana 44 |
| Warranty | Limited five-year warranty |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1970-1975 Jeep CJ5, the 1986 CJ7, the 1993-1998 Grand Cherokee (ZJ), the 2004-2006 Wrangler (LJ) Unlimited and Unlimited Rubicon, the 1997-2001 and 2003-2006 Wrangler (TJ) and the 2007-2011 Wrangler (JK).
Some Rubicon trims are included in the fit range, and the JK entries end at 2011. Confirm your vehicle’s year, model and trim before ordering.
What’s included
This part is a single axle bearing and cup.









