Overview
The Omix-ADA Dana 25 and 27 front axle brass spindle bushing, part 16529.02, is a replacement bushing for the spindle of those front axles. It fits early CJ and Willys models from 1946 to 1966.
A spindle bushing supports the steering spindle inside the knuckle. The bushing is made of brass.
Key features
- Brass bushing for the spindle
- Built to original Jeep specifications
- Fits Dana 25 and Dana 27 front axles
Spindle bushing wear and fit
The spindle bushing sits between the steering spindle and the knuckle bore, so it carries side loads as the wheel turns. When it wears, the spindle can move slightly, which shows up as play in the steering and uneven tire wear. Check the knuckle bore for scoring or ovality before fitting a new bushing, because a damaged bore will not hold the bushing properly.
Brass bushings are often chosen for steering spindles because they are a durable bearing material with reasonable wear behavior. Keep the bushing lubricated during assembly and follow the grease type the front axle requires. Dirt and water entering the knuckle accelerate wear, so check the seals and boots while the knuckle is apart.
Front-end work is best finished with a wheel alignment, since bushing wear changes the spindle angle. Re-check fasteners after the first few drives.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16529.02 |
| Axle application | Dana 25 and Dana 27 front axle |
| Material | Brass |
| Warranty | Limited five-year warranty. |
Vehicle fitment
It fits the 1946–1949 CJ-2, the 1949–1958 Willys CJ-3, the 1959–1960 CJ-3, the 1955–1958 Willys CJ-5, the 1959–1960 and 1966 CJ-5, and the 1956–1958 Willys CJ-6 and the 1959–1960 and 1966 CJ-6.
Jeep models from the 1970s on are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the spindle and knuckle bore for wear before fitting the new bushing.
What’s included
One brass spindle bushing.









