Overview
The Omix-ADA 16920.11 is a clutch cross shaft boot for 4 cylinder Jeep and Willys vehicles from 1941 through 1971. Two boots are needed per vehicle and they are sold separately, so plan for two per vehicle.
Key features
- Cross shaft boot for the clutch linkage
- Fits 4 cylinder engine applications
- Two required, sold separately
- Omix-ADA part number 16920.11
Protecting the clutch linkage
A cross shaft boot is a flexible cover that keeps dirt, water and grit away from the shaft and its bearing surfaces. Once the boot splits or hardens, contaminants can reach the shaft and accelerate wear on the bushings. Because the boots are installed in pairs on these applications, inspect both at the same time and replace them together so they wear evenly.
Off-road use exposes the linkage to mud, water crossings and trail debris, so boots can age faster than they would on pavement. Wipe the area clean during underbody checks, and look for grease that has been pushed out of the joint, which often shows a seal that has already failed.
- Look for cracks, splits or tears
- Check for hardened or brittle rubber
- Replace both boots together for even wear
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16920.11 |
| UPC | 804314068646 |
| Part type | Clutch cross shaft boot |
| Engine | 4 cylinder |
| Required per vehicle | Two |
Vehicle fitment
Covered years run from 1941 to 1971 across the CJ3, CJ5 and CJ6 with their CJ5A and CJ6A variants, the DJ and Dispatcher models, the FC and F4 trucks, the Jeepster and Utility, and Willys MB through Sedan Delivery.
Models built after 1971 and the CJ7 are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Each boot is sold separately, and two are needed per application. Other cross shaft parts are not part of the package.
Not included: the second boot and any other cross shaft parts.














