Overview
The Method Race Wheels 701 Trail Series 17×8.5 wheel in Bronze, part number MRWMR70178555900, is a 17-inch by 8.5-inch aluminum wheel built for off-road trail use. It has a 5 on 5.5 bolt pattern, a 108 center bore, 0 offset and 4.75 backspacing.
The wheel is cast as a single piece from 356 aluminum and T6 heat treated. The MR701 Bead Grip feature helps the tire bead stay gripped to the bead seat when pressure is reduced on rough ground. It is a universal fit wheel, so it is not built for one vehicle. Off-road owners can use the specifications below to check fit.
Key features
- One-piece cast 356 aluminum with T6 heat treatment
- Bead Grip technology for added tire bead grip at lower air pressures
- Reinforced inner lip based on Method’s race wheel design
- Safety hump on the inner and outer bead seat that helps stabilize the tire and prevent de-beading
- Development included Finite Element Analysis and field testing.
- No weight is available for this wheel, so compare weights directly if weight matters to your build.
- Windowed style in Bronze finish
Hub-centric fit basics
A hub-centric wheel sits on the hub itself rather than on the lug studs alone. When the hub diameter is larger than the wheel center bore, a ring of the correct size closes the gap and carries load through the hub. Without that centering, the wheel can wobble and wear the studs over time.
Before mounting, clean the hub face and remove any rust or paint buildup that could keep the wheel from sitting flat. Tighten the lug nuts in a star pattern, then recheck them after the first drive. Cracked or stretched studs should be replaced before the wheel goes back into service.
- Clean rust and debris from the hub face
- Tighten lug nuts in a star pattern
- Recheck torque after the first drive
Specifications
| Brand | Method Race Wheels |
|---|---|
| Part number | MRWMR70178555900 |
| Series | 701 Trail Series, MR701 Bead Grip |
| Wheel diameter | 17 inches |
| Wheel width | 8.5 inches |
| Bolt pattern | 5 on 5.5 |
| Center bore | 108 |
| Offset | 0 |
| Backspacing | 4.75 |
| Construction | One-piece cast 356 aluminum, T6 heat treated |
| Style | Windowed |
| Finish | Bronze |
Vehicle fitment
It is a universal fit wheel, so it is not written for a particular make, model or year. Fit comes down to matching the 5 on 5.5 bolt pattern, 108 center bore, 0 offset and 4.75 backspacing to your hub, with enough room for brakes and suspension.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Offset and backspacing control how far the wheel sits inside the fender, so measure caliper and suspension clearance with the planned tire before the first trail outing.
What’s included
Whether lug nuts, center caps or valve stems are included is unknown. Check the package contents against your installation before starting.
Not included: A tire must be purchased separately to mount on this wheel.
















