Overview
The Method Race Wheels MR315 17×9 is a 17-inch aluminum wheel with a 5 on 5 bolt pattern and part number MRWMR31579050312N. It has windowed styling, a machined finish, a 9 inch width, -12 offset, 4.55 backspacing and a 72 center bore.
The MR315 series is presented by Method Race Wheels as a line built for off-road racing use. The company says each wheel is engineered with Finite Element Analysis and tested in the field, with a design aim of reduced weight and increased strength. Pair the figures below with your vehicle’s hub specifications before mounting.
Key features
- Windowed MR315 design in a 17 inch diameter
- Machined finish on aluminum construction
- 9 inch wide wheel with -12 offset
- 5 on 5 bolt pattern with a 72 center bore
- 4.55 backspacing, a figure to check against inner clearance
- Engineering and field testing described by the maker
Negative offset and wheel position
A negative offset moves the mounting face outward from the hub centerline, so the outer edge of the tire sits farther out. That shift changes clearance at the fender lip, the steering components and the wheel bearing load, so check each one rather than only the fender.
Spacers and lift kits add to the outward position, which can stack with the existing offset. If a spacer is used, keep it to one piece per side and confirm studs remain fully engaged with the lug nuts before driving.
Inspect the wheel after the first few trips for contact marks on the outer lip and tire sidewall. Rubbing on the fender or caliper means the setup needs correcting before further use, not just a trim adjustment.
Specifications
| Brand | Method Race Wheels |
|---|---|
| Part number | MRWMR31579050312N |
| Series | MR315 |
| Wheel diameter | 17 Inches |
| Wheel width | 9 Inches |
| Bolt pattern | 5 on 5 |
| Center bore | 72 |
| Offset | -12 |
| Backspacing | 4.55 |
| Style | Windowed |
| Finish | Machined |
| Construction | Aluminum |
Vehicle fitment
This wheel is not matched to a specific vehicle. The 5 on 5 bolt pattern and 72 center bore must match the hub, and the -12 offset shifts the wheel outward on the hub.
Negative offset increases the outer clearance needed, so check the outer edge of the fender as well as the inner side. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The -12 offset pushes the mounting face outward, so the outer edge of the tire can reach closer to the fender lip, and the wheel’s position changes with any spacer or lift. Test-fit at full steering lock and check the 4.55 backspacing against the brake caliper before the vehicle is driven.
What’s included
Only the wheel itself is covered here. Tires and lug nuts still need to be arranged separately.
Not included: Tire and lug hardware must be arranged separately.











