Overview
The Smittybilt M1 front bumper for the 2015-2017 Ford F-150, part number 612833, is a two-piece steel winch bumper with D-ring mounts and S4 lights. Smittybilt engineered it to fit and follow the truck body, using 3/16 inch and 1/4 inch cold rolled steel with a solid 1/4 inch plate center section.
The bumper has a built-in winch plate for a winch up to 12k. The 7/8 inch solid D-rings are welded on the inside and out. Stainless steel bezel accents finish the look, and the bumper has no OE sensor holes.
Key features
- Two-piece design engineered to fit and follow the truck body
- Solid 1/4 inch plate center section
- 3/16 inch and 1/4 inch cold rolled steel construction
- Built-in winch plate for a winch up to 12k
- 7/8 inch solid D-rings welded on the inside and out
- S4 lights included
- Stainless steel bezel accents
- No OE sensor holes provided
Winch setup tips
A front winch changes how the bumper carries load, so the mounting points and the plate deserve a careful look before the first pull. Make sure the winch’s weight rating and bolt pattern suit the built-in plate, and tighten every bolt fully. Route the winch line so it stays clear of the lights and the bezel accents, and use a fairlead or a roller to reduce wear on the cable.
Inspect the bumper after recovery work, since a hard pull can shift the mounts or stress the welds on the D-rings. Look for cracks in the coat, loose hardware and any gap between the bumper and the frame. Keep a shackle and a tree strap in the vehicle so you can use the D-rings for recovery at the proper angle.
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 612833 |
| UPC | 631410125351 |
| Product type | Front bumper, M1 series |
| Position | Front |
| Material | Cold rolled steel, 3/16 inch and 1/4 inch |
| Finish | Smittybilt two-stage powder coat |
| Design | Two-piece |
| Winch capacity | Up to 12,000 lb |
| D-ring mounts | 7/8 inch solid, welded inside and out |
| Lights | S4 lights included |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2015-2017 Ford F-150. Confirm fit for your vehicle’s year, model and trim before ordering.
The 2018 and later F-150 and the Super Duty trucks are not covered by this part. Since the bumper has no OE sensor holes, trucks with front parking sensors will not have them reproduced. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
It is a bolt-on bumper that requires no drilling. Anything that relies on OE sensor holes will need a different solution, since the bumper has none.
What’s included
- Two-piece M1 front bumper
- 7/8 inch solid D-ring mounts
- S4 lights
- Stainless steel bezel accents
Not included: the winch (a winch up to 12,000 lb fits the plate).




















