Overview
The ICON Wrangler JL 2.5 Inch Rear Dual Rate Coil Spring Kit (part number ICO22026) is a rear coil spring set for the 2018–2026 Jeep Wrangler JL, in the 2-door and 4-door models listed. ICON gives 2.5 inches of lift, based on a factory-equipped 4-door Rubicon JL.
The rear springs use a dual rate design. The softer initial rate gives on-road comfort, and the firmer secondary rate increases during compression to resist bottoming out, which helps off-road.
Key features
- 2.5 inches of rear lift
- Dual rate coil design
- Softer initial rate for on-road comfort
- Firmer secondary rate for bottoming resistance
- Allows increased wheel travel with ICON shocks
- Room for larger tires
- Black finish
- Lifetime guarantee against sagging and breakage
Rear dual rate and shocks
A dual rate rear spring works by starting soft and firming up as it compresses. That gives a comfortable ride on pavement and better control when the rear axle reaches the bottom of its travel on trail. Matching the spring to the shock is what makes the setup feel balanced.
When the rear is raised, the driveline angles and the shock length change. Check the pinion angle, rear brake lines and bump stops after installation. The rear height also affects how the vehicle sits when loaded, so measure the height with a typical load before deciding the setup is finished.
Rear springs can take a set over time, especially on a vehicle used for towing or carrying gear. Inspect for sagging, cracked coatings and worn shock mounts at routine service visits.
- Check pinion angle after installation
- Look at shock length and mounts
- Inspect bump stops and brake lines
Specifications
| Brand | ICON Vehicle Dynamics |
|---|---|
| Part number | ICO22026 |
| Position | Rear |
| Lift height | 2 to 3.5 inches (listed range); 2.5 inches on a factory 4-door Rubicon JL |
| Spring design | Dual rate |
| Color | Black |
| Warranty | Lifetime guarantee against sagging and breakage |
| Fitment type | Direct fit |
Vehicle fitment
ICON lists these rear springs for the 2018–2026 Jeep Wrangler (JL) in both 2-door and 4-door models.
The list does not include the Gladiator, and the Wrangler JK and JL models outside 2018–2026 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A rear 2.5-inch lift changes the rear height without raising the front, so check the rear driveline angle and the shock length after installation.
Allowing more wheel travel works best when the shocks are matched to the springs, so use ICON shocks for a better fit. The dual rate design helps keep the rear stable under load while the ride stays comfortable on the road.
What’s included
The rear coil springs in the kit. No other components come in the kit, so line up the parts list with your install before starting.





