Overview
These are front coil springs for (’14+) Ram 2500 and (’13+) 3500 4WD trucks, leveling the front end by 2.5 inches. The design is dual rate, with a soft initial ride zone followed by a firmer second rate that helps prevent bottoming out.
The springs are pre-set and shot peened to resist sagging. Matching extended length shocks are engineered for maximum droop and compression travel, and pairing them with the springs completes the setup.
Key features
- Dual rate spring design with an initial soft ride zone
- Aggressive second rate to help prevent bottoming out
- Dual stage powder coat finish to help prevent corrosion
- Shot peened and pre-set to prevent sagging
- Set of 2 front springs for a 2.5 inch lift
- Designed to work with Icon extended length front shocks
Matching springs and shocks
Front coil springs carry a large share of the truck’s weight, and a lift changes how the whole front end sits. Raising the front shifts the suspension geometry, so control arms, ball joints and the steering components work at different angles than they did from the factory. A dual rate spring keeps the first part of the travel soft for daily driving, then firms up to hold the truck under heavy loads or hard braking.
When choosing a lift, plan for the parts that often get replaced with it: extended length shocks, brake line extensions, and sometimes bump stops. Check that the new front height leaves enough clearance for the tires at full steering lock and full compression. After installation, look for rubbing, uneven tire wear or a front end that feels unsettled over bumps, and have the setup inspected if any appear.
Specifications
| Brand | Icon Suspension |
|---|---|
| UPC | 700007202951 |
| Position | Front |
| Lift height | 2.5 inch |
| Quantity | Set of 2 |
| Spring design | Dual rate |
| Finish | Dual stage powder coat |
| Application | (’14+) Ram 2500 / (’13+) 3500 4WD |
Vehicle fitment
The springs are for (’14+) Ram 2500 / (’13+) 3500 4WD trucks. Confirm fit for your vehicle’s year, model and trim before installing.
The stated application is 4WD, so two-wheel-drive trucks are not covered, and rear suspension parts are not included. Confirm your vehicle’s year, model and trim before installing.
Installation notes
Front extended length shocks are required for a complete installation, so plan on fitting matching Icon shocks at the same time. Lift springs change front height and geometry, so have the front alignment checked afterward and confirm driveline angles.
What’s included
Set of 2 front coil springs for a 2.5 inch lift.
Not included: front extended length shocks, which are required for complete installation.
