Overview
The ICON adjustable front track bar, part number ICO64035, is built for 2005 to 2016 Ford Super Duty F-250 and F-350 trucks. It realigns the front track within factory specifications. The bar can be used with 0 to 9 inches of lift, and any lift over 5.5 inches requires a drop-down bracket for the track bar.
The bar installs with the factory hardware and can be adjusted on the truck without removing it. It comes with an FK rod end bearing and machined rod end spacers, which ICON says reduce the deflection of the stock bushing setup.
A track bar keeps the front axle centered side to side. When a lift changes the geometry, a bar that is the wrong length can pull the truck off center, so an adjustable bar lets you set the length to bring alignment back within specification.
Key features
- Adjustable front track bar, realigns the front track
- Usable with 0 to 9 inches of lift
- Drop-down bracket required for lifts over 5.5 inches
- Adjusts on the truck without removal
- FK rod end bearing and machined rod end spacers
- Installs with factory hardware
Lift height and bracket choice
A front track bar works with the steering and axle geometry, so lift height has to be part of the setup decision. Small lifts usually change the axle angle only a little, while taller setups push the bar further from its original position. Know your lift height before you pick the bar and bracket.
Bracket decisions are often where installs go wrong. A drop-down bracket changes the mounting point of the bar, so it keeps the bar close to level once the height changes. Mount it with the hardware intended for the bracket and check clearance against the steering components and the frame.
Related parts often get replaced at the same time. Worn ball joints, tie rod ends and bushings allow the axle to shift, which makes a new bar less effective. Inspect those parts when you install the bar, and recheck alignment after the first drive.
- Measure lift height before choosing a bracket
- Check clearance around the steering components
- Inspect ball joints and tie rod ends
- Recheck alignment after the first road test
Specifications
| Brand | ICON Vehicle Dynamics |
|---|---|
| Part number | ICO64035 |
| Position | Front |
| Lift range | 0 to 9 in. |
| Drop-down bracket | Required above a 5.5 in. lift |
| Rod ends | FK rod end bearing with machined spacers |
| Fit | Direct fit |
Vehicle fitment
It is built for 2005 to 2016 Ford F-250 and F-350 Super Duty models, including the Cabela’s, FX4, Harley-Davidson Edition, King Ranch, Lariat, Platinum, XL and XLT trims.
Super Duty years outside 2005 to 2016 and other Ford trucks are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install the bar with the factory hardware. Any lift over 5.5 inches needs the drop-down bracket, and the alignment should be checked after the bar is set.
What’s included
The adjustable track bar with its FK rod end bearing and machined rod end spacers. Not included: the drop-down bracket needed for lifts over 5.5 inches.




